torque specs in Nm and tightening esquence
when u buy a head gasket for the car usually the toque settings or on a piece of paper in the packet
torque settings for a vauxhall 1.7 td clinder head
can u plz tell me the head cylinder tightening torues and also the camshaft tichtening torques on 1.6 16v vectra 2009 thanx n also do i need 2 replace the old headbolts
Wt is the opel astra160i camshaft settings
For a 1994 Astra with a 1.4-liter engine, the cylinder head torque settings typically require an initial torque of around 20 Nm (15 lb-ft), followed by a further 90-degree turn of the bolts. It's important to follow the specific tightening sequence and ensure that the surface is clean and free of debris. Always refer to the vehicle's service manual for the most accurate specifications and procedures.
For the Opel Astra 2000 model with the 1.8 16V engine, the torque settings for the cylinder head bolts are typically around 25 Nm (18 lb-ft) initially, followed by a further torque angle of 90 degrees. For the camshaft bearing caps, the torque setting is generally around 10 Nm (7 lb-ft). Always refer to the specific service manual for your vehicle for the most accurate and detailed specifications.
Astra f 1800cc 16v renew bolts 25nm 90 degrees 90 degrees 90 degrees
You have not told us for what bolt or nut ?. There will be almost a whole page of torque settings for that vehicle. Oilpan bolts may be as little as 12 while cylinder head bolts will be around 65-70 . We have no clue unless you name the bolt.
On the Astra G (1998-2003) it is under a cover in the center console under the emergency brake handle.
check spark plugs and coil pack
i have also lost the piece of paper, need the answer asap as im working on the car now. thank you
Could be a variety of causes Cam angle sensor to thermostat