0
What else can I help you with?
What is the engine size in cc's for a 2002 Vauxhall vectra 1.8?
1800 cc's.
Where is the engine number located on a vauxhall vectra 1800?
Errrr. On the engine block (big heavy bit on the bottom)
What is the correct compression ratio for a Vauxhall Vectra 1800?
The correct compression ratio for a Vauxhall Vectra 1.8 (commonly referred to as the 1800) is typically around 10.5:1, depending on the specific model and engine variant. This ratio helps optimize performance and fuel efficiency while maintaining engine reliability. Always refer to the vehicle's manual or manufacturer specifications for precise information related to a particular engine.
What is the firing order for a 1996 corolla with an 1800 cc four cylinder engine?
1-3-4-2
What is the firing order for a 1987 vw gti golf 1800?
The firing order for all VW 4 cylinder engines is 1-3-4-2, with cylinder no.1 next to the camshaft pulley wheel.
How do you change front light bulb on vectra 2006 1800 petrol?
go to halfords they'll do it for you,
In what order are the spark plugs from front to back of the engine on a 1983 Honda Accord 4-cylinder 1800 series?
The spark plug closest to the alternator belt is #1. Firing order should be 1-3-4-2.
What does this mean P0170 -11 vectra c 1800?
fuel trim fault usually caused by air leak on inlet or maf faulty
Where is the fuel pressure regulator on a 2000 vectra sri with xe1 engine?
Its in the fuel tank along side the fuel pump.I have to buy one as my 1800 is over fuelling
What is the firing order for a Mazda mx3 1800 v6?
1-2-3-4-5-6 with #1 being at the front of the engine on the rear bank (nearest the firewall). The rear bank is numbered 1-3-5 and the front is 2-4-6
Hand Brake Light sign does not go off after the release of Hand Brake of Ford Taurus 2005.?
I have a 1800 vectra and the break light comes on when traveling then goes off, is this the brake shoes or pads wearing out.
Went to pull away uphill in Vectra 1800 but now engine is misfiring ticks over Ok any suggestions?
I had this problem with mine, then the engine management light would come on. Turned out to be the crankshaft sensor. (Cambelt off job)
