103 ft/lbs
29 foot pounds
torque wrench settings for the xv,xw,and the xy engine cylinder head bolts are stage 1 50nm or 37 foot pounds stage 2 77nm or 57 foot pounds
63 foot pounds.
46 foot pounds on short bolts 54 foot pounds on long bolts + 90 degees
90 inch - pounds (torque) = 90 / 12 = 7.5 foot pounds (torque)
First start from middle out. 32 foot pounds. then repeat with 64 foot ponds.
You should measure the diameter of the bolts concerned. The information I have applies to the 250 cc as well as the 100 cc versions of this bike. For the 10 mm cylinder head bolts they torque to 27 to 31 foot-pounds. The 6 mm head bolts torque from 7 to10 foot-pounds. The 8mm cylinder cover bolt should torque from 15 to 20 foot-pounds. Hope this helps. .
Spark Plug Gap is .035, Torque then to 20 foot pounds.
Cylinder Head Bolts for 1988-1997 Festiva and Aspire 1.3L I4 Engine Step one: 35-40 foot pounds Step two: 56-60 foot pounds
Torque settings on 1300 Toyota Tazz are torque to 59 foot-pounds, loosen one full-turn. Then, torque 37 foot-pounds and 68 foot-pounds. Torque sequence is 6, 4, 2, 8,7, 3, 1, 5.
Its is 20 foot pounds took me all day on my bike to find out what it was
Tighten the drain plug using a two-finger rule till it feels snug(drain plug requires less torque [15 - 25 ft. lbs] than many torque wrenches can be set to, many begin at 25-30ftlbs)so best to NOT use a torque wrenchhowever, if you have a smaller torque wrench , I found this information elsewhere"For the 4.0L six-cylinder, torque the drain plug to 18 foot-pounds of torque. For the 4.6L eight-cylinder, use 19 foot-pounds of torque."