answersLogoWhite

0

93,

This engine has a compression ratio that should allow it to use regular unleaded gasoline.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How many 1973 450sl Mercedes were made?

Approximately 26,000 units of the 1973 Mercedes-Benz 450SL were produced. This model was part of the R107 series, which was manufactured from 1971 to 1989. The 450SL featured a V8 engine and was popular for its blend of luxury and performance. Its production numbers contributed to its status as a classic car today.


What is the best year for Mercedes 450sl?

1979


Where is the fuse on 1975 Mercedes 450sl?

in barbados


1976 Mercedes 450sl oil capacity?

8 quarts


How do you jump start a 1978 Mercedes 450SL?

trunk is the battery


What is the spark plug gap for a 1977 Mercedes 450SL?

The spark plug gap for your Mercedes is .032


How do you release the hood of a 1973 Mercedes 450SL?

To release the hood of a 1973 Mercedes 450SL, first, locate the hood release lever inside the vehicle, which is typically found near the driver's side footwell. Pull the lever to unlock the hood. Next, move to the front of the car and find the secondary hood release latch, usually located at the center of the grille. Push or lift this latch to fully open the hood.


Where is the fuel pump on a 73 Mercedes 450sl located?

The fuel pump on a 1973 Mercedes 450SL is located on the driver's side of the vehicle, near the rear, just in front of the fuel tank. It is mounted on the chassis and is typically secured with bolts. Accessing it may require lifting the car for better visibility and maneuverability. Always ensure safety precautions are followed when working on fuel systems.


How do you replace a rear transmission seal on a 1973 Mercedes-Benz 450sl?

To replace the rear transmission seal on a 1973 Mercedes-Benz 450SL, first, ensure the vehicle is securely lifted and supported. Remove the driveshaft and any components obstructing access to the transmission. Carefully remove the old seal using a seal puller or flat tool, then clean the sealing surface. Install the new seal by gently pressing it into place, ensuring it is seated evenly, and reassemble the driveshaft and any removed parts.


What is the spark plug gap for a 1978 Mercedes 450SL?

.028 to .032 Champion N9Y or N10Y


On 1979 Mercedes 450sl light with round circle is on?

if it looks like [0] or similar its the e brake light


How do you remove the drag link 1978 Mercedes 450sl?

¿quienes realizaron los primeros graffitis en argentina?