Approximately 26,000 units of the 1973 Mercedes-Benz 450SL were produced. This model was part of the R107 series, which was manufactured from 1971 to 1989. The 450SL featured a V8 engine and was popular for its blend of luxury and performance. Its production numbers contributed to its status as a classic car today.
93, This engine has a compression ratio that should allow it to use regular unleaded gasoline.
Figure $350 for a rebuilt unit, $100-150 to install.
To release the hood of a 1973 Mercedes 450SL, first, locate the hood release lever inside the vehicle, which is typically found near the driver's side footwell. Pull the lever to unlock the hood. Next, move to the front of the car and find the secondary hood release latch, usually located at the center of the grille. Push or lift this latch to fully open the hood.
A-108 transmission.
I have a 1975 450Sl and the ICU is located on the driver's side, in the front wheel well on the fender just below the coil. It's a cast aluminum looking box. Otherwise, running from your distributor is a covered wire that holds two internal wires (I think two)... trace that back as it will lead you to your ICU. Tim
The fuel pump on a 1973 Mercedes 450SL is located on the driver's side of the vehicle, near the rear, just in front of the fuel tank. It is mounted on the chassis and is typically secured with bolts. Accessing it may require lifting the car for better visibility and maneuverability. Always ensure safety precautions are followed when working on fuel systems.
It is a 2 speed automatic transmission that General Motors used from 1950-1973.
It should tell you right on the transmission dipstick.
how do replace an accellerator cable on a 1973 bug
In a 1973 Dodge Coronet , the 318 was set at ( TDC ) with the automatic transmission ( a 1973 manual transmission equipped 318 was set at 2 and 1/2 degrees BTDC )
How I have to do for replace a little bulb on the ODO speedometer cable on 1973 Super Beetle ?