In a Fiat Doblo, the bonnet release cable is typically located near the driver's side footwell. You can find the release lever on the lower left side of the dashboard, just above the pedals. Pulling this lever will unlock the bonnet, allowing you to access the engine compartment. If you have trouble locating it, consulting the owner's manual can provide more specific guidance.
If your Fiat Doblo 1.9JTD is not displaying total mileage, the cable can be loose. Check the cable to ensure it is connected tightly.
how to remove a drive shaft on a fiat doblo
how to replace brake light bulb fiat doblo van
There should be a cable hanging down from where the latch was. Just grip with a pair of pliers and give it a gentle pull. You will hear a click and then you can release and go to the front of the car and open the bonnet.If the level is slack - it points to a snapped bonnet release cable.To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car.I jacked up the car, placed it on a stand on the passenger side, and reached up underneath. I've videoed it - quick to do once you see it.http://bit.ly/Yh1dQ9TAG: Fiat Punto, Bonnet Cable, Snapped Bonnet Cable
HOW How do you FIT A NEW a fiat doblo 1.9jtd fan belt?Read more: How_do_you_adjust_a_fiat_doblo_1.9jtd_fan_belt
AnswerThe Bonnet is called the Hood in the U.S. Pull the lever inside the car, on drivers side. Then release the hood (bonnet) with the lever located in the front grille.If the level is slack - it points to a snapped bonnet release cable.To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car.I jacked up the car, placed it on a stand on the passenger side, and reached up underneath. I've videoed it - quick to do once you see it.http://bit.ly/Yh1dQ9TAG: Fiat Punto, Bonnet Cable, Snapped Bonnet Cable
Only a FIAT dealer can do this.
Pull the handle on the drivers side to release it and then put your hand - palm up - through the gap at the front of bonnet in the middle so your fingers can lift the final release handle. If the gas struts are u/s then it will be very heavy to lift.If the level is slack - it points to a snapped bonnet release cable.To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car.I jacked up the car, placed it on a stand on the passenger side, and reached up underneath. I've videoed it - quick to do once you see it.Go to related links below.http://bit.ly/Yh1dQ9TAG: Fiat Punto, Bonnet Cable, Snapped Bonnet Cable
It is not recommended by the manufacturer to remove the speed limiter on a Fiat Doblo. The speed limiter is installed for the safety of the vehicle operator.
electrical
Using a Long screwdriver and bright light, find the retaining spring through front grille and release it.
The latch release lever is on the driver's side on the floor next to the door. If the level is slack it points to a snapped bonnet release cable. To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car. Jack up the car, placed it on a stand on the passenger side, and reached up underneath. Watch the video: http://bit.ly/Yh1dQ9