On the passenger side in the wheel well behind the front wheel. Pull the front passenger side wheel and remove the wheel well cover. The charcoal canister is attached to the firewall in the wheel well. The Leak Detection pump is in front of the passenger side wheel below the air cleaner assy.
like the charcoal canister could be located in the passeanger wheel well.
It is the same as a 98' Corolla. It is attached to the back of the gas tank.
The speed sensor on a 98 Jetta is located near the brake setup. It is on the passenger wheel area mounted to a bracket.
The canister purge valve on a 98 Eclipse is located on the front of the car. It is on the right corner of the bumper.
On a 98 it is located on the front valve cover. It's a little black box with 2 hoses and a wire going into it right in the front of you when you open the hood. Not sure about a 2001 but I hope that points you in the right direction.
Fuse box on 98 Jetta is located under steering wheel above pedals.
its on the top of the bellhowsing and on the differential case
serpentine belt diagram for 98 jetta tdi
On back side of motor under the intake manifold
It is by the canister box right in front of the tank.
The canister purge valve on a 1998 Isuzu Amigo with a 2.2L engine is typically located near the engine bay, mounted on or near the intake manifold. It is part of the evaporative emissions control system and connects to the charcoal canister and intake. To access it, you may need to remove some components or hoses for better visibility. Always refer to a repair manual for specific locations and procedures.
How do I check transmition fluid n 98 vw jetta vr6 2.8