0
On a 1998 European BMW M3, the crank position sensor is typically located on the engine block, near the flywheel. It is usually positioned on the driver's side, towards the bottom of the engine. To access it, you may need to remove the undertray or some components in the vicinity for better visibility. Always refer to a service manual for detailed instructions specific to your vehicle model.
What else can I help you with?
If the crank position sensor 1998 Dodge Dakota magnun v6 is not work what would happen?
If the crank sensor is not working, the engine will not run.
What does a crank shaft sensor do on a 1998 Honda accord?
A crank shaft position sensor on a 1998 Honda Accord reads whether or not a the engine is spinning correctly. If there is a discrepancy on how the crankshaft is spinning the sensor will relay it to the ECU.
Where is the cam position sensor control on a 1998 v6 mustang?
it is down by the crank pulley
What happens when the crank sensor or cam position sensor goes out in a 1998 Chevy Malibu?
crank sensor will cause car to no start cam sensor will only set check engine light kbutlrtech@yahoo.com
Where is the crank sensor located on 1998 Bravada?
the crank sensor is located just behind the crank shaft pully of the engine.
Crank position sensor on a 1998 kia sportage?
standing in front of car it is right rear upper drivers side.
Where is the location of the crank sensor on a 1998 Mitsubishi eclipse spyder 2.4l engine?
The crankshaft position sensor is located on the front of the engine inside the timing belt cover
Where is the crank position sensor on a 1998 Dodge Dakota 5.2L?
Top of the bell housing, pass side, behind the cylinder head.
Where is crank shaft position sensor on Hyundai accent 1.3l 3 door 1998 model?
The HyundaiÊ1.3 liter engine crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
Your 1998 Bonneville will not start have replaced the battery the starter was replaced last year do you have any ideal what it may be?
COULD BE THE CRANK POSITION SENSOR
Can you change the crankshaft sensor without having to change the whole distributor on a 1998 Chrysler cirrus?
The crank sensor is not in the distributor, it is in the top of the bell housing. The cam position sensor is in the distributor and is not available separately
Is the crank sensor the same as the cam sensor on a 1998 ford escort wagon?
No
