it is on the motor block on the driver's side. Look just ahead of the transmission bell housing just above the oil pan....you will see the wire ...the actual plug- in is covered with a Mickey Mouse fiberglass heat shield and is usually covered with grease and dirt and is almost inaccessible because of the exhaust pipe...A good cleaning with degreaser and high pressure water spray should reveal the little bugger
The crankshaft sensor on the 1998 NISSAN ALTIMA is located next to the radiator side of the harmonic balancer
The 1998 Montero Sport crankshaft sensor will be located on the rear of the engine. The crankshaft sensor is on the inside of the rear engine cover.
where is the fuse panel for a land rover
No
Right next to and somewhat behind the crankshaft pulley
On front cover of engine by crankshaft pulley.
To replace the front ABS brake sensor on a 1998 Land Rover Discovery LE, first, safely lift and support the vehicle. Locate the ABS sensor on the wheel hub assembly, disconnect the electrical connector, and remove the retaining bolt securing the sensor in place. Carefully pull out the old sensor and insert the new one, securing it with the bolt and reconnecting the electrical connector. Finally, lower the vehicle and test the brakes to ensure proper function.
The crankshaft position sensor on a 1998 3.0 dodge caravan is located on the top of the bellhousing towards the firewall.
check the crankshaft sensor or the cam sensor.
The crankshaft position sensor is located on the front side of the engine block near the flywheel/driveplate
the crankshaft position sensor is located right behind the harmonic balancer mounted on the timing cover
hgydfuihjopjopkp[