In a Peugeot 307, the cruise control micro switch is typically located on the brake pedal assembly. It is activated when the brake pedal is pressed, which disables the cruise control system. To access it, you may need to remove the lower dashboard panel for better visibility. Always consult the vehicle's service manual for specific details and safety precautions.
To start a Peugeot 307 with a faulty multifunction switch, you can bypass the switch temporarily. First, locate the wiring harness connected to the multifunction switch, then use a jumper wire to connect the appropriate terminals that control the ignition. Ensure safety by disconnecting the battery before making any connections. However, this is a temporary solution; it's advisable to replace the faulty switch for a permanent fix.
Peugeot 307 fog light switch, is a ring located on same lever used to activate direction light. According Peugeot 307 equipment, it could have rear and front or just rear fog light
In order to change the brake light switch in a Peugeot 307, you must dismantle and access the main light board on the dash and find the connecting switch, thusly flipping it back to the on position.
It is a plunger type switch screwed into the top of the transmission casing.
To determine if there's a dimmer switch for the dashboard in a specific vehicle model, such as one labeled "307," you would need to consult the owner's manual or look for a dedicated control on the dashboard or steering column. Most modern vehicles have a dimmer switch, typically located near the headlight controls. If you're unable to find it, checking online forums or contacting the manufacturer could provide additional insights.
To open the front small window in a Peugeot 307, locate the window control switch on the driver's door or the corresponding switch on the passenger door, depending on which window you want to open. Press and hold the switch down to lower the window and pull it up to raise it. If the window is a manual type, use the hand crank located on the door panel. Always ensure the ignition is on for electric windows to function.
This is a common fault on the 307 and will require a new stalk switch module. Sorry : (
what do the different dashboard symbols mean on a 2003 peugeot 307 mean
most relays are found in the fuse box ,which relay are you looking for.
To change the indicator switch on a Peugeot 307 SW, first disconnect the car battery to ensure safety. Remove the steering column cover by unscrewing any screws and gently prying it apart. Then, locate the indicator switch, disconnect the wiring harness, and remove the switch by unscrewing it from the steering column. Finally, install the new switch, reconnect the wiring, reassemble the steering column cover, and reconnect the battery.
There could be several possible reasons why the brake lights stay on all the time on a 307. The most common reasons would be a bad relay or a bad switch.
The heater matrix can be replaced by removing the heater core and temperature control cables. Replace the heater core and the control cables.