answersLogoWhite

0

The Fuse for Licence Plate Lights on a Jaguar XJ8 [1999] is Located in the Fuse Box in the boot/Trunk on the right hand side it is Fuse No.-19 and is a 5AMP one.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Which tectonic plate is Sicily situated on?

The Plates Are: Eurasian Plate and The African Plate!


What plate tectonic is Haiti situated on?

It is situated near the edge of the Caribbean plate and the North American plate


What is the bulb number for the license plate on a freestar?

The bulb number is W5WL. This information is typically found in the owners manual for all the bulbs in your vehicle.


Russia is located on what crustal plate?

eurasian plate


How do you Change licence plate bulbs on a Honda Civic?

Well if you open your trunk you will be able to access your plate bulbs and help you change them with ease.


What is the name of Floridas tectonic plate?

Florida is situated on the North American tectonic plate.


What plate is mount Tarawera on?

Mount Tarawera is situated on the Pacific Plate, which is an oceanic tectonic plate beneath the Pacific Ocean.


What bulbs go in a s-10?

Headlight bulbs, high and low beam, parking light bulbs, signal light bulbs, brake light bulbs, dash light bulbs, interior light bulbs, plate light bulbs, etc.


Where does plate tectonics situated in layer of ocean?

earthquakes and volcanoes


Where is the vin for 1967 Jaguar mk2 car?

The term "Vehicle Identification Number" or VIN was not used in 1967, but there were equivalents used by most all automobile manufacturers. In the case of the Jaguar Mk2, an identification plate is riveted at the top-center of the firewall under the hood. This plate is stamped with a "Chassis No.", "Body No.", "Engine No." and "Transmission No.". The chassis number is the equivalent of a VIN and should be the identification number listed on the car's registration.


How i change number plate bulbs on a suzuki grand vitara?

To change the number plate bulbs on a Suzuki Grand Vitara, first, open the rear hatch and locate the number plate light assembly. Carefully pry off the lens cover using a flathead screwdriver or a similar tool. Remove the old bulb by turning it counterclockwise, then replace it with a new bulb and reassemble the lens cover. Test the new bulb to ensure it’s working before closing the hatch.


How do you change the license plate light bulbs on a 96 Pathfinder Le?

you need to remove the inside panel to get to these bulbs