The heater resistor on a MK5 Polo is typically located behind the dashboard, near the heater box. To access it, you may need to remove the lower dashboard trim and possibly the glove compartment. The resistor is usually mounted in a plastic housing and connected to the wiring harness. Always consult your vehicle's service manual for specific instructions and safety precautions before attempting to locate or replace it.
To replace the heater resistor in a 2006 VW Polo, first ensure the vehicle is turned off and disconnect the battery to prevent any electrical issues. Locate the heater resistor, typically found behind the glove compartment or under the dashboard on the passenger side. Remove the screws or clips holding it in place, disconnect the wiring harness, and then replace it with the new resistor. Finally, reassemble everything and reconnect the battery to test the new resistor.
no. but you can make it fit. but you have to make alot of changes to the bumper and is load of work.
where to find heater resistor 2004
Heater blower resistor is what controls the low medium high speeds...
location of heater blower resistor 2005 renault laguna
where is the heater blower resistor in a 2003 Honda element
Location of 2007 heater blower Transistor resistor
The most recent version of the Volkswagen Polo is the Polo Mk5. Wikipedia has an article on this car. Additionally, some of Volkswagen's websites have information about the Polo, although their American website does not because there are no plans to release the Polo in North America.
The heater resistor coil is located on the blower motor on the 2006 T300 Kenworth.
In general the heater blower motor speed resistor is located in close proximity to the blower motor.
Changing a front wing on a mini Volkswagen Polo MK5 should be done only through your car dealer or a certified garage that has access to Volkswagen parts. While the job may look simple, it needs to be done correctly as does any other change in parts.
the heater blower resistor is located on the passenger side footwell near the firewall. a complete how-to replace the resistor, along with photos is available on newcougar.org http://www.newcougar.org/forums/how-tos/3732-fixing-heater-blower-resistor-install-photos.html