The OBD-II plug on a 2003 Peugeot 307 petrol model is typically located under the dashboard, near the driver's side. You can usually find it around the area where the steering column meets the dashboard, often slightly to the left. It's usually enclosed in a small plastic cover or panel that may need to be removed for access.
To change the gearbox oil on a Peugeot 306 petrol, start by ensuring the vehicle is on a level surface and secure it with wheel chocks. Remove the drain plug from the gearbox and let the old oil drain completely into a container. Once drained, replace the drain plug and remove the fill plug on the side of the gearbox. Using a funnel, add the recommended gearbox oil until it reaches the fill level, then replace the fill plug securely.
The spark plug gap should be set to the manufacturers spec, regardless of vehicle.
Recomended type of plug for peugeot 1.4 03 plate
To top up the gearbox oil on a Peugeot 306 petrol, locate the gearbox fill plug, which is typically situated on the side of the gearbox casing. Use a suitable tool, usually a socket or wrench, to remove the plug. Once removed, you can add the oil using a funnel or a squeeze bottle until it reaches the correct level, which should be just below the fill hole. Make sure to replace the plug securely after topping up.
hi the plug is on the drivers side just to right below the steering wheel you should have a little pocket for putting items in you will see a little button you need to unscrew it left and pull the whole parts off and there you will find the diagnostic plug
The torque setting for the sump plug bolt on a Peugeot 106 1.1 petrol (2000 W reg) is typically around 20 Nm (15 lb-ft). It's important to ensure the bolt is tightened properly to prevent leaks without overtightening, which can damage the threads. Always consult the vehicle's service manual for the most accurate specifications.
It is either underneath the steering wheel to the right in the glove compartment or underneath the plastic underneath the ashtray. Just lift the black plastic up.
under the dash on the drivers side near the clutch/brake pedal should be 16 pin obd11
0.9MM with spark plug gap tool.
Anyone? I have not found the plug either.
The glow plug relay unit is attached to the battery housing on the 405
0.9mm.