The oil separator on a BMW Z3 is typically located on the engine block, near the back of the engine, often close to the intake manifold. It is part of the crankcase ventilation system, helping to separate oil from the blow-by gases. Accessing it may require removing other components, depending on the specific engine model. Always consult the vehicle's service manual for precise location and replacement instructions.
The sensor is located at the front of the engine near the oil filter housing. To the left of the housing. 2.5 Z3
If you mean where do you put oil in, there should be a large square plastic cap located on top of the engine.
In the trunk.
6.9 liters
There is no cabin filter on this car.
6.9 quarts
The BMW z4 replaced the BMW z3 in late 2002. The BMW z3 was introduced in 1996 shortly after staring in a James Bond movie. Not as easy on the eyes as the z3 but just as nice.
the 328i BMW if it is the M52 engine should be using 5w30 synthetic oil, same as the 2.8 Z3
no
7 US quarts
In a BMW Z3, the oil dipstick is located on the engine, typically towards the front or side, depending on the specific engine model. To access it, you may need to open the hood and look for a yellow or orange handle. Pulling this handle will remove the dipstick for you to check the oil level. Always ensure the engine is off and cool before checking the oil level for safety and accuracy.
How do you charge a 2002 BMW Z3 battery