0
What else can I help you with?
1983 Porsche 944 wont start but crank?
check to see if your tack is not jumping it could be a bad ref sensor
Where is the water temp sensor located on 1983 ford bronco six cylinder?
The temp sensor is located on the intake manifold
Where is the oxygen sensor on a 1983 Camaro?
On the driverside exaust manifold under the hood
How do you reset the Clifford Model 8 alarm on a 1983 Porsche 944?
porsche 911 sc 1983
How heavy is a Porsche?
My 1983 Porsche 944 is 3,000 pounds
Where is the o2 sensor located in a 1983 Oldsmobile delta 88?
In a 1983 Oldsmobile Delta 88, the oxygen sensor is typically located on the exhaust manifold or just downstream of it in the exhaust pipe. It may be found near the catalytic converter if the vehicle is equipped with one. If you're having trouble locating it, consulting the service manual for your specific model can provide additional guidance.
How to replace crankshaft position sensor on a 1983 mercury grand marquis 302 v8 engine?
1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.
How do you test the air flow sensor in a 1983 Porsche 928?
Disconnect it. If it runs the same or better, have it rebuilt $200 from Python Injection, out of California. Borrowing another one would be best.
How much is a 1983 Porsche worth?
look at autotrader.com
Neutral safety switch location on 1983 Thunder Bird?
it is in the exhaust pipe. The neutral safety switch stops you from starting a car unless it is in neutral or park so can not be located in the exhaust pipe. You maybe thinking of the oxygen sensor...
What is the sound warning light for in a 1983 Volvo 242 dl?
I have the same car and had the same issue. the SOND light is your oxygen sensor.
Where is the crankshaft position sensor located on 1983 Porsche 944?
if you look on the rear of the motor from the top where the clutch cover meets the block look down between the brake master and intake it has two wires on top and looks like part of the clutch cover but its not very hard to unbolt 6mm Allen head bolts
