its to the front of your car inside ,below your dash board,open your door left or right front doors and look under to the left side or right side ,where you or your passenger feet would be
The P38A was made from 1995-2002. The L322 is the current model and is much more luxurious
Behind the battery
High Specification Edition A HSE is the lowest spec for the l322 (unless its for the police then they do an SE) On a P38 series Range Rover HSE is one of the base models, but not the lowest. The lowest is 'County SE' , then HSE, then Vogue, then Vogue se Vogue LSE (range rover classic ) then 'Autobiography'.
difference
Land Rover 32mm threaded fans are Left Hand threads, the 36mm threaded fans (which I think you have) are normal/ right hand threads.
Yes, you can switch the headlight beam on a 2003 Range Rover L322 from left-hand to right-hand drive. This typically involves adjusting the headlight assembly to change the beam pattern, which may include repositioning the headlight lenses or using an adjustment feature, if available. It's advisable to consult the owner’s manual or a professional service to ensure proper alignment and compliance with local regulations.
To sync your key fob on a 2004 Range Rover L322, first, sit inside the vehicle with all doors closed. Insert the key into the ignition and turn it to the "ON" position without starting the engine. Press and hold the "lock" button on the key fob for about 10 seconds, then release it. Finally, turn the ignition off and test the key fob by locking and unlocking the doors.
The maximum towing capacity of the Range Rover L322 varies depending on the engine and model year, but it generally ranges from about 3,500 kg (7,700 lbs) to 3,850 kg (8,500 lbs) for certain diesel models. Always consult the owner's manual or manufacturer specifications for the exact towing capacity of your specific vehicle configuration.
To remove the seat armrests on an L322 Range Rover, first, locate the screws or bolts securing the armrests to the seat frame, which may be hidden under a plastic cover or upholstery. Use a Torx or appropriate screwdriver to remove these fasteners. Once the screws are out, gently pull the armrest away from the seat, being cautious of any clips or wiring that may be attached. Finally, disconnect any wiring if necessary and remove the armrest completely.
It depends on the year and how your drive it, but my P38 returns 12 city and 17 highway and my L322 returns 14 city and 18 highway.... my 2000 range rover hse 4.6 get just about 12 around town,but on highway iam getting near 20 miles a gallon if i keep it at 55 to 60 miles an hour,i just had my plugs and wires newly replaced,most the time when iam done my long trip i will get a bit over 18 miles a gallon,because i just cant keep going 60 mph the whole way!
Autodiagnos Ltd St Christopher House, 217 Wellington Road South, Stockport, SK2 6NG, UK Tel: 0161 209 4470 Fax: 0161 209 4488 Email: info@autodiagnos.com www.autodiagnos.com Registered Office: Autodiagnos Ltd, 5 Pullman Court, Great Western Road, Gloucester GL1 3ND Registered No: 3062855 Service light reset - Land Rover The procedures described below are relevant to the following European specification models: Model Chassis Model year Discovery 3 / LR3 L319 2005 to 2006 Range Rover L322 2002 to 2004 Range Rover Sport (not supercharged) L320 2005 to 2006 1) Procedure to check/reset service status - Distance counter ? Switch ignition OFF ? Press and Hold left instrument panel reset button, switch ignition ON to position 'I' (accessories) ? Keep reset button pressed for approximately 5 seconds until the LCD displays 'RESET SIA'. The distance to service (e.g. 2150 miles) and the service type (e.g. Inspection/oil service) will be displayed. ? Has the 'Reset Distance' limit been reached or exceeded? o NO - Follow instructions in section 2 below o YES - Follow 'Reset Distance Counter' instructions below Reset Distance counter procedure ? Press and hold left instrument reset button for 5 seconds. 'RESET' will begin to flash on the LCD display. ? To reset distance the left hand button should be pressed before the 'RESET' message has flashed 5 times ? The LCD will display 'END SIA'. Switch ignition off 2) Procedure to check/reset service status - Date counter ? Press left instrument panel reset button once ? The LCD will display 'RESET SIA' followed by the service due date. ? Has the 'Reset Date limit been reached or exceeded? o NO - Press the left instrument button once. The LCD will display 'END SIA' to indicate the service interval check/reset procedure has been cancelled. o YES - Follow 'Reset Date Counter' instructions below Reset Date counter procedure ? Press and hold left instrument reset button for 5 seconds. 'RESET' will begin to flash on the LCD display. ? To reset distance the left hand button should be pressed before the 'RESET' message has flashed 5 times ? The LCD will display 'END SIA'. Switch ignition off
Autodiagnos Ltd St Christopher House, 217 Wellington Road South, Stockport, SK2 6NG, UK Tel: 0161 209 4470 Fax: 0161 209 4488 Email: info@autodiagnos.com www.autodiagnos.com Registered Office: Autodiagnos Ltd, 5 Pullman Court, Great Western Road, Gloucester GL1 3ND Registered No: 3062855 Service light reset - Land Rover The procedures described below are relevant to the following European specification models: Model Chassis Model year Discovery 3 / LR3 L319 2005 to 2006 Range Rover L322 2002 to 2004 Range Rover Sport (not supercharged) L320 2005 to 2006 1) Procedure to check/reset service status - Distance counter ? Switch ignition OFF ? Press and Hold left instrument panel reset button, switch ignition ON to position 'I' (accessories) ? Keep reset button pressed for approximately 5 seconds until the LCD displays 'RESET SIA'. The distance to service (e.g. 2150 miles) and the service type (e.g. Inspection/oil service) will be displayed. ? Has the 'Reset Distance' limit been reached or exceeded? o NO - Follow instructions in section 2 below o YES - Follow 'Reset Distance Counter' instructions below Reset Distance counter procedure ? Press and hold left instrument reset button for 5 seconds. 'RESET' will begin to flash on the LCD display. ? To reset distance the left hand button should be pressed before the 'RESET' message has flashed 5 times ? The LCD will display 'END SIA'. Switch ignition off 2) Procedure to check/reset service status - Date counter ? Press left instrument panel reset button once ? The LCD will display 'RESET SIA' followed by the service due date. ? Has the 'Reset Date limit been reached or exceeded? o NO - Press the left instrument button once. The LCD will display 'END SIA' to indicate the service interval check/reset procedure has been cancelled. o YES - Follow 'Reset Date Counter' instructions below Reset Date counter procedure ? Press and hold left instrument reset button for 5 seconds. 'RESET' will begin to flash on the LCD display. ? To reset distance the left hand button should be pressed before the 'RESET' message has flashed 5 times ? The LCD will display 'END SIA'. Switch ignition off