the switch is located on top of the gearbox,under the airfilterbox
probably the switch stuck on. pull out fuse in mean time
Here you go http://www.peugeotlogic.com/fuses/fuses406/fuses1.htm
It is a plunger type switch screwed into the top of the transmission casing.
The relay switch for the washer motor on a 2001 model Peugeot 406 Estate is located at the controls of the windshield washer. It is near the washer fuse.?æ
The Peugeot 406 Rapier Estate inertia switch is located between the brake master cylinder and the upper left suspension mount. This is the same as the Fuel Supply cut-off.
WHERE THE HOM ON THE peugeot 406 2.0hdi out sade
it says in manual that its behind the steering column only if its not a automatic
were will i get information for 1996 peugeot 406 petrol
To change the brake light switch on a Peugeot 406, first, disconnect the vehicle's battery to ensure safety. Locate the brake light switch, usually situated near the brake pedal assembly, and disconnect the electrical connector. Remove the old switch by unscrewing it or twisting it out, then install the new switch by reversing the removal process. Finally, reconnect the electrical connector and the battery, and test the brake lights to ensure they function properly.
On a Peugeot 406, the reversing light wires are typically green and brown. The green wire is generally the positive connection, while the brown wire serves as the negative. However, it's always best to consult the vehicle's specific wiring diagram for confirmation, as colors may vary slightly between models or production years.
Hi You shoudnt have one, just put it in reverse Nathan