The Speed Sensor (for 2.5 V-6) is located in the Transmission housing Drivers side behind the Dipstick Oil tube under the Distributor (hard to see!), you must remove the tube in order to access the sensor or replace it. It is a Cylindrical sensor with a tab on it for screwing it to the transmission, screw holding it is a 10mm.
To disconnect the horn of a Chrysler Cirrus, first, ensure the vehicle is turned off and the keys are removed from the ignition. Open the hood and locate the horn, which is typically found near the front of the engine compartment. Disconnect the electrical connector attached to the horn by gently pulling it off. If necessary, you can also remove the horn from its mounting bracket by unscrewing it for further disconnection.
To add Freon to a 1999 Chrysler Cirrus, first ensure the vehicle is parked and the engine is off. Locate the low-pressure service port, which is typically found on the larger diameter line between the evaporator and compressor. Attach the refrigerant can to the low-pressure port, start the engine with the AC on maximum, and slowly release the Freon until the system reaches the appropriate pressure. Monitor the pressure gauge during the process to avoid overcharging.
the water pump is locate in back of the motor bracket on the left side of the engine it take about 4 hours to remove it
Locate fuse, pull old out, push new in.
If what is mean is how do you locate the batter to replace it in certain models of the Chrysler Concorde such as the 2003 model.... the answer is to remove the driver side tire and fender. The batter is located in the fender skirt. Tracy Gibson of Virginia
To get to the battery take the driver's front wheel off.remove the 1/4 in.bolts from the inner fender liner the battery is located inside the access panel there.You need a 1/2 in. socket to loosen the hold down remove the heater wrapping and replace the battery and heater
Four cylinder, rear of engine below exhaust manifold. V6, front of engine behind motor mount.
trying to replace the starter on a 1995 3.3 dodge intrepid! what problems if any can i anticipate?
Need to know what it is you want to locate.
locate the alternator take off the belt put new one on then the belt and your done
It is just below and behind on the area where the upper radiator hose attaches to the engine.
did u ever figure it out?