You have a problem with the engine controls, have the codes read at the dealer or an auto parts store and make the necessary repairs and the light will go out, or it can be reset by the tech.
With the proper scan tool.
Not necessarily.
Have vehicle scanned to determine the problem
why is subaru forester 1998 hold light flashing
To reset the check engine light in a 2003 Subaru Forester, you can disconnect the negative battery terminal for about 15 minutes. This will clear the vehicle's onboard computer and potentially turn off the light. Alternatively, you can use an OBD-II scanner to clear the trouble codes that triggered the light. However, it's important to address the underlying issue that caused the light to come on to prevent it from reappearing.
you need a scanner to scan your cars computer to see what is causing it to happen
Replacing the battery was not likely the cause of your check engine light. Most auto parts stores have a code reader will read the code for you at no charge and reset the light.
To reset the service light in a Subaru Forester, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within 10 seconds. Afterward, turn the ignition off and then start the engine to check if the service light has been reset. If it remains on, you may need to repeat the process or consult your owner's manual for specific instructions based on your model year.
To reset the check engine light on a 2003 Subaru Forester, you can disconnect the negative battery terminal for about 15 minutes, then reconnect it. Alternatively, you can use an OBD-II scanner to clear the error codes after addressing the underlying issues. Ensure that any problems that triggered the code are resolved to prevent the light from reappearing. Always check the vehicle’s manual for specific instructions related to your model.
On my Subaru Forester the instrument panel lamps are dimmed by turning a ring on the turn signal stalk.
1. You have a problem with the cruise control. or 2. If your check engine light is also on, get the code read, cancel the light and the cruise indicator light will probably quit flashing and the cruise will start working again.
A flashing cruise control light in your 2009 Subaru Forester, alongside a steady check engine light, typically indicates a problem with the vehicle's engine or transmission that may affect the cruise control system. This could be due to various issues, such as a malfunctioning sensor or a serious engine fault. It's advisable to have your vehicle diagnosed with an OBD-II scanner to identify the specific trouble codes, which can guide necessary repairs. Ignoring these warnings can lead to further damage, so addressing them promptly is crucial.