The most likely cause is a faulty engine crankshaft position sensor.
Stop light sensors are a loop of wire that is buried in the pavement and controls the traffic light. The sensors are able to detect the traffic that is waiting at the light.
Means you are over heating.
It would be a good idea, this way you dont get stuck in traffic idling thru the green light.
It's done with a code reader plugged into diagnostic port under dash.
Turn only after there is no danger from oncoming vehicles
Traffic light sensors work by using various detection technologies such as inductive loops, video cameras, or radar sensors to monitor traffic flow at an intersection. These sensors can detect the presence of vehicles waiting at the intersection and communicate this information to the traffic signal controller. The controller then uses this data to optimize the timing of the traffic lights and improve traffic flow.
There are a few reasons why a car shakes when idling at a red light. Some reasons could be the ignition coil, motor mounts, or spark plug problems.
The opposite would be "light traffic".
Your Dodge Durango may stall when idling at a stop light for a couple of reason. One reason may be that a part needs to be replaced on the car.
If a traffic light breaks most cities will assign a traffic cop to regulate traffic until the light can be fixed.
your not so bright
Yes. That is why they are called traffic lights.