answersLogoWhite

0

A common mistake is that people wire the back up light loom to the wrong side of the coil.

Remember that the loom that feeds the backup light plugs into the 15 circuit (engine switched 12v to run).

The 1 circuit is the negative side of the coil that is for the ignition points only.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Car stall in reverse gear only?

There are several reasons that a car may stall only in reverse, the best way to narrow down the issue is to use a diagnostic tool. The diagnostic tool will show which sensors on the transmission may be malfunctioning enough to stall the engine.


My 99 infiniti g20 engine to stall when engine is cold during take off in drive or reverse.?

Change your transmission oil it happen to me . And have your mechanic check the transmission you might have metal shavings in the transmission which is really bad.


Why would the engine almost stall in a 1996 ford f150 5.0 when put into reverse?

transmission filter not properly seated in the valve body, causing it to stall when engaging reverse gear, wouldnt have believed it if i personally hadnt experienced the exact same problem myself.


Why does a 1973 727 transmission make the engine stall when placed in drive or reverse?

I really doubt it's the tranny making your car stall, it's either carburetor problems or the idle is set too low.


Why would an engine seem to almost stall when put in reverse but idle fine in park engine is 94 351 windsor?

Why would it stall or almost stall in Reverse but not in Drive? How long since it's received a tune-up and thorough check-up? How is the compression?


What causes an automatic transmission not to idle?

If you mean each time you engage car in any gear forward or reverse & it immediately stalls - you have a bad torque converter. Start engine, put foot on brake, put car in NEUTRAL, if it DOES NOT stall, but it does stall if you repeat this test when you put car in drive or reverse = bad torque converter - It's called a "stall test"


Why does your Ford F-250 stall when put in reverse?

No, that would indicate transmission problems, is it a standard or and auto?


Why would a car stall shifting from park to reverse?

A car might stall when shifting from park to reverse if the idle is set too low. It is also possible that the engine stalls because it is not fully warmed up before shifting from park to reverse.


Why would a car stall in drive but not in reverse?

Because reverse is a lower ratio gear than drive and puts less load on the engine.


What might cause a 1995 Dodge Avenger to stall out every time you throw it into reverse?

One possible cause for a 1995 Dodge Avenger stalling when shifted into reverse could be a faulty idle air control valve. This component is responsible for regulating the engine's idle speed, so if it is malfunctioning, the engine could stall when the transmission is engaged in reverse. It is recommended to have the idle air control valve inspected and potentially replaced to address this issue.


What would cause a transmission of a1992 Buick lesebre to shrudder as the engine shuts down?

what will cause a transmission in a 1992 buick lasebre to shrudderas and stall engine


Why does a Dodge truck stall when put in reverse?

If it is a standard transmission, you would need to slowly let out the clutch while backing up.