answersLogoWhite

0

does your car have a sensor in the dash or anywhere else for automatic lights on and off, it looks like a small ball. it works off of the same principle as a night light, when it is dark enough it the lights will come on, and vice versa, so check to see if you have one or if there is any papers on the dash clean it off. if this does not work and you so have a sensor like the one I described, it is probably bad

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

The headlights on your 1995 es300 are dim- you have polished the exterior covers still dim?

These are projector headlights, not regular reflectors. you must polish the inner lenses as well-- these are the two spheres visible inside the headlights. open headlight case and polish away. Ajax followed by whitening toothpaste works.


Head light switch 93 topaz?

The headlight switch on a 1993 Mercury Topaz is typically located on the dashboard to the left of the steering wheel. It allows you to turn the headlights on and off, as well as control other exterior lights such as the parking lights and fog lights. If you are experiencing issues with your headlights, it is recommended to check the fuse, bulbs, and wiring before replacing the headlight switch.


What is a cheap alternative to costly headlight cleaner products?

A cheap alternative to costly headlight cleaners is toothpaste. Cleaning the interior and exterior of your headlights with toothpaste will leave them clear and shiny. The grit in the toothpaste helps remove dirt and bug residue that accumulates while driving. It is a great cost effective means of cleaning your headlights. Toothpaste averages about 1.50$ per tube and will last you through various cleanings.


Why would your headlights and dash lights blink on 1999 Geo Tracker?

Blinking lights on dash and exterior lights may indicate a bad ground wire or a faulty headlight switch. Both would cause those problems.


1996 ram driving lights relay located?

The exterior lights do not have a relay. They are directly turned on by the headlight switch.


How far away should the disconnect switch be located from an exterior hot tub?

5 feet


Exterior electrical disconnect is required in sight of what?

It is usually expressed the other way around. The electrical disconnect has to be within 20 feet and line of sight of the equipment you are working on.


Exterior compressor is missing the breaker at the exterior service disconnect The Heat which is also effective by this also didn't operate what problem?

It sounds like one leg of your service distribution is open.


How do you replace the passenger side mirror on a 2005 Ford Focus?

Removal and Installation Remove the trim panel. Release the clip. Release the locating tabs. Remove the trim panel. Disconnect the exterior mirror control switch electrical connector. Disconnect the exterior mirror electrical connector. Release the clip. Release the electrical connector. Disconnect the electrical connector. Remove the exterior mirror. Remove the bolt. If equipped, remove the screw. To install, reverse the removal procedure.


How do you remove a Lexus RX headlight glass?

the headlamp glass is a non serviceable item, you can not disassemble the plastic exterior from the headlamp module. if your exterior lens is foggy from uv discoloration you may find after market products to clean and restore the clear lens.


What does the light bulb on the dashboard of a Mercedes c280 mean?

the light bulb on you dashboard means you have and exterior light out if it isn't you headlights blinkers....ect its probably just a short


How do you remove the head light covers on a 2000 Kia Sephia so they can be cleaned or replaced?

When you open the hood of the car, there are 2 bolts that hold the headlights onto the car, one on the top of the headlight assembly and one on the front of the assessembly (facing outwards at the front of the car. Remove the bolts, and gently pull the headlight outwards and angle it upwards a bit, to clear the side body molding. You can not remove the clear plastic covers on the front of the headlight without ruining the seal, so I wouldn't recommend it; however, if your lights look cloudy and foggy, it is most likely the exterior of the plastic, and there are kits available at most car parts stores that will remove that oxydation and discolouring.