First what is wrong with you headlight switch on your 93 topaz.
The diagnostic port on a 1993 Mercury Topaz is typically located under the dashboard on the driver's side. It is often found near the steering column, and it may be covered by a removable panel. It is used for connecting a diagnostic scanner to read and troubleshoot the vehicle's computer systems.
To read the trouble codes in a 1993 Ford Topaz, you need to locate the diagnostic connector, usually found under the dashboard near the driver's side. Once you find the connector, you can use a code reader or jumper wire to extract the trouble codes, which will flash on the check engine light. Refer to a repair manual specific to your vehicle to interpret the codes.
Unless I miss my guessw it's in the same place that it is on my 93. Just to the left of the steering column under the dash panel. You have to get into the floor and look up to see anything in it....... One of FORDS Better ideas :)>
Heat from the sun travels approximately 93 million miles to reach Earth. This journey takes about 8 minutes and 20 seconds at the speed of light.
The switching is done within the transmission by internal pressure. YOu may just be low on fluid. I have had this happen to my 93 topaz three times (plus a fourth that happened before I got the car). Every time it happened the fluid level was full. The tranny used (ATX) on the topaz has a governor on it. If the governor is not set right it will not shift. I have had to have the governor gear replaced Dec. 2005 because of this. Once you have one problem with the transmission you may have problems the rest of the car's life. I am now on my 4th transmission.
replace head light switch on 93 ford explorer
Its just a geuss. but on my 93 mercury topaz the head light switch alsoe controls the lights in side the care. If it's clicked all the way on that might be why.
under the brake pedal
the ash lights come on when you turn your park/ head lights on are so you may have a faulty head light switch!
brake light switch is broken or out of adjustment. brake light switch is located above brake pedal.
The head light switch is shorting out ,or a bad connection
The 1993 Mercury Sable backup light relay switch can be found beneath the drivers side dashboard. The backup light relay switch will be above the accelerator pedal.
The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.
take it to a dealer
Make sure switch in trunk is in proper position
I would be thinking it is a head gasket.
are you thinking about the dimmer switch or the actual illumination light? on the left side of the steering wheel you will find the dimmer switch, and the dash becomes illuminated from the first click of your headlight switch.