answersLogoWhite

0

In a Renault Clio with an automatic transmission, the engine will not start while in drive (D) or reverse (R) for safety reasons. The vehicle is designed to only allow the engine to start when it is in park (P) or neutral (N). This feature prevents unintended movement of the car when starting the engine.

User Avatar

AnswerBot

2d ago

What else can I help you with?

Related Questions

Why would a car stall in drive but not in reverse?

Because reverse is a lower ratio gear than drive and puts less load on the engine.


Where is reverse light switch on a Renault clio?

its underneath the car plugged into the gearbox at the side of the nearside drive shaft. mine is blue


Why would an engine seem to almost stall when put in reverse but idle fine in park engine is 94 351 windsor?

Why would it stall or almost stall in Reverse but not in Drive? How long since it's received a tune-up and thorough check-up? How is the compression?


Why does the check engine light come on after putting car in drive and reverse several times?

You have to get the engine looked at.


Is the Renault laguna front wheel drive?

Is a Renault Laguna a front wheel drive


Why is a Lincoln LS V8 making a engine noise when it is shifted into drive or reverse?

If a Lincoln LS V8 is making a engine noise when it is shifted into drive or reverse, it could indicate a seized gear in the transmission. It could also indicate a low transmission fluid warning.


Diesel powerstroke Engine dies when you shift from drive to reverse?

sounds like the auto transmission has a fault


When l start my Lexus SC400 and put it in reverse the engine cuts out why l can't go anywhere l need to reverse in my drive to get out?

buy a mercedes


How do you make a car drive if when its in neutral or drive it wants to move but won't and when its in reverse it will reverse?

it will drive but when in reverse it wont move


What causes the vehicle to lunge forward or backward when the transmission is placed in drive or reverse?

Engine idle too high.


Why would a 1997 Ford Contour shake or vibrate at idle at stoplights and even more so when the air is on?

check your engine monts you can do this by having someone stand a long side of the car looking at the engine put the car into drive and se if the engine jerks left or right go back and forth to drive and reverse if it moves a lot then your engine mont is bad


What would cause a Nissan Altima transmission to hesitate when putting it into drive or reverse?

I was told by my mechanic that the transmission hesitating after putting it in drive after reversing is a sign of the transmisison dying. ---------- Check transmission fluid. When the fluid is low there is not enough in the torque converter, so when you go to reverse or drive you have to rev the engine before it moves to compensate for less fluid in the torque converter.