0
Are we talking about the pins that hold on door??
If so a pliers,screwdriver + hammer will do you may need someone to support door when taking of and putting back on slight taps of th hammer and screwdriver to the pins directly will loosen them also using some wd40 oil will make this easier then when loose tightly clamp pins with pliers and they should slide right out....dont go gentle
What else can I help you with?
Is the passenger door of a 1999 GMC Yukon glued on if so how do you replace it?
No, You need to remove the door panel, the door wiring, pull it all through the large hole in the front of the door, and remove the door pins, there are usually lock washers that are hard to see that need to be removed to slide the pins out good luck!
How to rekey a lock?
To rekey a lock, you will need a rekeying kit that matches the brand of your lock. Remove the lock cylinder from the door and take out the old pins. Insert the new key into the lock and use the rekeying tool to set the new pins to match the new key. Reassemble the lock and test it with the new key to ensure it works properly.
How do you rekey a lock to change the key that operates it?
To rekey a lock and change the key that operates it, you need to remove the lock cylinder from the door, take out the old pins inside the cylinder, and replace them with new pins that match the cuts of the new key. This process allows the lock to be operated by the new key instead of the old one.
How can I remove a door from its hinges?
To remove a door from its hinges, follow these steps: Locate the hinge pins on the door. Use a hammer and a flathead screwdriver to tap the hinge pins upward and out of the hinges. Once the pins are removed, lift the door off the hinges. Be sure to have someone help you support the weight of the door as you remove it.
How to rekey a lock effectively and efficiently?
To rekey a lock effectively and efficiently, you will need to follow these steps: Remove the lock cylinder from the door. Take out the old pins and springs from the cylinder. Insert the new pins and springs according to the new key's pattern. Test the new key to ensure it works smoothly. Reassemble the lock cylinder and reinstall it in the door. By following these steps carefully and using the right tools, you can rekey a lock effectively and efficiently.
How do you rekey a door lock to ensure security and control access to your property?
To rekey a door lock for security and access control, you need to remove the lock cylinder, replace the pins inside with new ones, and then reassemble the lock. This process ensures that only those with the new key can access the property, enhancing security.
How do you replace door hinge bushings on a 1993 Nissan Sentra?
Have to remove the door, then remove pins and bushings
How do you replaced a car door?
Open door look at the hinge remove two pins holding it on and remove door place it on ground, pick up new door put pins back onto the hinge well holding door and you should be done.
How do you remove front door?
remove the pins from the hinges there is probrably a clip on the bottom of the pin
How do I remove the door of a Samsung fridge?
To remove the door of a Samsung fridge, locate the hinge cover on the top of the door and remove it. Then, unscrew the hinge screws and lift the door off the hinge pins.
How do you remove the door from 1991 Chevy Blazer?
Remove the inner kick panel. Disconnect the wiring harness. Drive the pins out of the hinges - remove door.
How do you take off the doors on a 1985 blazer?
remove the door pins
