answersLogoWhite

0

its probably the one cable broke or the outer come out of the bracket it fits into,the way to get at it is to take off the front bumper/fender then you can take the front flashers out (with a good pull) then both headlights then unplug both foglights and you can then get at the catches easy without breaking anything,destroying the grill will not help at all the bumper is held on by 3 nuts each side ,it just slides out of the side panels and you can take it off on the floor in about 1 hour

vaughan

england

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the hood latch to open hood 1988 Volvo?

where is any hood latch? usually located near the drivers left foot, under the dash board.....


How do you open the hood on a 94 geo with a broken hood latch cable?

If it is just the inside handle broken off you can pull the cable with a pair of pliers. If it is in the middle, you should be able to reach up from underneath and cut the cable and then pull the inside cable. If the latch end has pulled off, you may be able to trip the latch from underneath, or take the grill out and unbolt the latch.


How do you replace a drivers side door latch cable on a 2001 Toyota Sequoia?

To replace the driver's side door latch cable on a 2001 Toyota Sequoia, start by removing the interior door panel by unscrewing the fasteners and gently prying it off. Disconnect the old latch cable from the door latch mechanism and the inside handle. Install the new cable by attaching it to the latch and the handle, then reassemble the door panel, ensuring everything is secured properly. Finally, test the door operation to ensure the new cable is functioning correctly.


How do you open hood on Volvo S60 when the latch will not work?

The hood on a Volvo S60 can be opened when the latch is not working by sticking a stiff piece of wire into the grill and pulling on the release latch. The latch can then be repaired or replaced.


How do you open a bonnet on a Fiat Palio Go 2006 when the latch is broken?

The latch is broken, not the cable. You can still get to the cable where it is attached to the latch in the foot-well of the car. Grab the cable with a small vice-grip (or similar) and pull. Note that it is very unlikely the cable will break -the latch typically breaks before the cable since the latch is made from plastic and the cable from steel wire.


How can open the hood if the cable broken for volvo s70 1999?

If the hood release cable is broken on a 1999 Volvo S70, you can try using a long, flat tool like a screwdriver to reach the hood latch. Look for a small gap near the grill or under the front edge of the hood where you can insert the tool to manually pull the latch. Alternatively, you can access the latch from underneath the vehicle if you can safely lift it, or consider removing the front grill for better access. If these methods don't work, a professional mechanic can assist in opening the hood.


Volvo XC90 Hood cable broken how can I open the hood?

If the hood release cable on your Volvo XC90 is broken, you can try to access the hood latch manually. Use a flat-head screwdriver or a similar tool to reach the latch mechanism through the grille or the gap between the hood and fender. Alternatively, you can have someone pull on the release lever inside the vehicle while you gently press down on the hood to relieve tension on the latch. If these methods don't work, consider consulting a professional mechanic for assistance.


How do you change the hood latch cable on a 1990 Pontiac Firebird when you cannot find the answers in your repair manual?

It depends on what is wrong with the cable. When you pull the hood release within the car, is the latch not popping? If you can get the hood up at all, then you should look at the actual latch system where the cable runs, there is a metal clip that holds the cable to the latch. Have another person pull the interior latch release and watch the cable.


How do you change the hood latch on a 1994 Chevy Corsica?

MY LATCH BROKE OFF IN SIDE THE CAR. IF THE HOOD IS OPEN, LOCATE WHERE THE CABLE GOES THRU THE FIREWALL ON THE DRIVERS SIDE. PULL OUT THE CABLE FROM THE FIR WALL. DO NOT DISCONNECT FROM THE LATCH. PUT 1 BAR OF A COAT HANGER THRU THE HOLE UNTIL IT IS SEEN FROM THE BOTTOM. TIE A LONG STRING AROUND THE PART OF THE COAT HANGER THAT IS IN THE CAR. PULL THE HANGER OUT FROMT HE TOP. MAKE SURE TO LEAVE STRING IN THE CAB OF THE CAR. TIE THE END OF THE NEW CABLE (DEALER PART ONLY, ABOUT $35)TO THE STRING. PULL THE STING FROM THE TOP. YOU WILL SEE THE CABLE COME THRU. FOLLOW THE PATH OF THE OLD CABLE TO THE LATCH. DICONNECT FROM THE LATCH AND REPLACE WITH THE NEW CABLE. RECONNECT THE LATCH INSIDE OF THE CAR TO THE PLASTIC


How do you repair the hood latch for the 1991 Mercedes 190E 2.6 the handle in the car that opens the hood does not work it does not pop the hood?

The hood is openned by a cable that links the handle in the car the hood latch. If the cable is broken or detached then the hood will not open. The cable has two parts, an outer covering and the actual cable that pulls on the hood latch when the inside handle is pulled, you need to check the inside handle to see if the cable is still attached to the handle, also you need to check the hood latch to see if that end is still attached to the hood latch. If either is disconnected the you will need to get appropriate hardware(nuts,bolts etc) to attach it back but if the cable is broken it has to be replaced complete. This you might or might not be able to do depending on you skill and proficiency with tools.


Where is the Volvo trunk latch?

There is none. Use the key.


How do you open the hood of your Volvo s70 if the cable is broke?

If the hood release cable is broken on your Volvo S70, you can open the hood manually by accessing the latch mechanism directly. First, locate the hood release lever under the dashboard and inspect the cable; if it's detached, you may be able to pull on the cable itself with pliers. If that doesn't work, you can reach under the front grille or use a long screwdriver to push the lever of the hood latch, which is typically located near the center. It may take some finesse, but this should allow you to lift the hood.