answersLogoWhite

0

if yopu have replaced battery in remote key fob put key in ignition then turn to postion1 the press the buttons on the fob a few times this simply resets the fob to the car then alll will work as should do

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Why won't my remote lock or unlock central locking but remote still sets alarm?

check the remote and the connections in the vehicle..or mabey you bought a faulty alarm system.


Where is central locking relay on ford KA?

If the car has an alarm system or remote locking (Key fob) the locking control box is behind the side trim in the (UK) passenger footwell, if there is no alarm there is no relay box the system works off the door being locked and it sends a lock command to the other door


Disabling ford puma alarm system?

There is a module behind the carpet..drivers side next to where your right foot goes. Top plug is alarm, pull this out to disable.....Be aware this is also linked to the remote central locking so doors may have to be locked manually......Hope this helps There is a module behind the carpet..drivers side next to where your right foot goes. Top plug is alarm, pull this out to disable.....Be aware this is also linked to the remote central locking so doors may have to be locked manually......Hope this helps


Can you stop your alarm from going off in your vauxhall vectra by taking out any fuses?

Yes, you can stop the alarm from going off in a Vauxhall Vectra by removing certain fuses related to the alarm system. Typically, this would involve pulling the fuse for the alarm or central locking system. However, doing so may disable other functions as well, and it's advisable to consult the vehicle's manual for the correct fuse location and to consider resolving the underlying issue with the alarm system instead.


Is it alarm remote or remote alarm?

An alarm remote is a remote control for an alarm system. A remote alarm is an alarm that rings somewhere far away from whatever set off the alarm.


Where can you get a wiring diagram for central locking for your 2001 Hi ace van would like 2 make it remote central locking?

2nd Drivers door motor will need to be added in addition two relays that will be controlled from lock-unlock pulse from alarm module or after market module. Relays also feed power to door motor.


Why would my Car alarm just stop working but the locking still works on remote?

some car alarms have a backup battery in them. thses batteries if worn out can stop the alarm working.also sometimes the battery in the remote needs replacing to work


How to activate the alarm on 2001 Acura CL?

On your keyless entry remote hold down the panic button and trunk button at the same time till the remote light flashes. Then the "beep beep" of the alarm will sound when locking and unlocking your car.


Why would doors be locking and unlocking on your 97 Taurus it has no alarm or remote?

one of two reasons, someone is messing with you or you have a short (i.e. a wire that's split and arcs) in the wiring on your locking system.


How to lock VW Sharan without setting alarm?

if locking the car with the key, not with the remote, then yo ucan lock the car and disengage the alarm by turning the key to the left once to lock the car then a second time to disable the alarm.


Can you put a car alarm on a car with no power locks?

Yes you can put an alarm on a car with no power locks, you can even buy central locking system that you can fit to a car with no power locking system that will connect up to the alarm system. Danny from Bee Mech Mobile Mechanics Find me at www.beemech.com.au


Replaced battery in remote now red light comes on remote and car central locking and alarm goes on is it remote or fault in remote?

I had a problem too when I removed the battery from my Mentor's remote . Do the following ,sit inside the car , remove the remote battery , wait for 1 minute , replace the remote battery when doing so you will see that the remote light is on ! If the light is not on try again ! Now press and hold the lock button on the remote until you hesar the doors lock . Your remote is now programed .