A size 32W (waist) and 30M (inseam) in sweatpants typically indicates that the waistband measures 32 inches around, while the inseam (length from the crotch to the bottom of the leg) is 30 inches. This size is common for individuals with a medium build. When choosing sweatpants, it's essential to consider both the waist and inseam measurements for a proper fit.
That pants size means a 32 inch waist and a 36 inch length of the inseam. This type of measurements are used for men's pants.
Plus size label is usually marked with a W after the number. The sizes range from 14W to 32W
A size 32W and 30L typically refers to men's pants with a waist measurement of 32 inches and an inseam length of 30 inches. The "W" stands for waist, while the "L" represents the length. This sizing is common in denim and trousers, providing a standard fit for individuals with these measurements.
If you mean: 32w+8 then it can be factored to 8(4w+1)
1907.
On average, a 32W T8 fluorescent bulb running 24 hours a day for 30 days at an average electricity rate of $0.12 per kilowatt-hour would cost about $7.84 per month.
Around $600-$700
I'm assuming you have a Marlin model 1889, not 1887, as they never made a model 1887. The 1889 does have a patent date of 1887 on the barrel, so this is a common mistake. Any Marlin marked ".32W" on the barrel will normally be chambered for the .32-20 Win. cartridge.
These tubes need a ballast to operate the tubes. The current and voltage will be marked on the fixtures ballast.
The value of a Remington 32W, also known as the Remington Model 32, can vary significantly based on its condition, specific model, and any unique features. Generally, prices can range from a few hundred to over a thousand dollars for well-maintained examples, with collector interest affecting the market. For an accurate appraisal, it's best to consult a firearms expert or check recent sales of similar models.
Your rifle was built in 1942 but the value will depend on the overall condition of the rifle. The best site I have found for dating rifles is oldguns.net that is where I came up with your information.
To calculate the load in amps for the circuit, first determine the total wattage of the fixtures. The four 150W incandescent fixtures contribute 600W (4 x 150W), and the six fluorescent fixtures (assuming a typical wattage of 32W each) contribute 192W (6 x 32W). Adding these together gives a total of 792W. Using the formula ( \text{Amps} = \frac{\text{Watts}}{\text{Volts}} ), the load in amps is ( \frac{792W}{120V} = 6.6A ).