0
No doubt you can put them together but they are from entirely different regions and should be kept under totally different conditions. Orandas are 'GOLDFISH/CARP' and come from cooler waters. Gouramies are 'ANABANTIDS' and come from the tropical Asian rainforests. Work it out!
What else can I help you with?
Can you breed common goldfish and red cap oranda fish together?
A common goldfish can be bred with a red cap oranda fish. When these fish breed, there is a definite courtship ritual.
How do you breed red cap oranda fish?
To breed red cap oranda fish, create a breeding tank with good water quality and plenty of hiding spots. Pair a male and a female, and provide a spawning medium like plants or a spawning mop. Maintain the water temperature around 75-80°F and feed them a varied diet to encourage breeding.
Can you keep different kinds of goldfish in one tank?
Aslong as it has enough room and filtration many types of goldfish can be kept together. There are some cases where problems occur as such as the case with Sarassas and Orandas. Sarassas will tend to nibble at the cap of the Oranda causing damage.
How do you get Minish Cap Flame Lantern?
In the Temple of Droplets
How did a lamplighter put the lamps out?
He had a device with a little cap on one end. It fit over the flame and snuffed it out.
How do I fit PVC cap and plug together?
with PVC glue
Do romeo monty and juliette cap have to end up together?
No They will only be together if you make them. It depends on how you play the game.
What type of simple machine is bottle cap?
A bottle cap is a type of screw, which is a simple machine used to fasten objects together by rotating them into place.
What would we observe if we put a plastic cap on a piece of paper over a burning flame?
we would the cup and the paper burn like when you put news paper on a bbq.
How do you make a wig cap?
you can tye the end of two legs of a pair of tights together.
Can esgic plus cap and xanax be taken together?
Can esgic and clonpins be taken togeter
How do you braze a copper pipe end?
Brazing is a process used to join a gap in piping or other metal parts. It is technically impossible to do on only one end, since the way it works requires two sides to work in. Tried to answer this last night and was edited out. I'll try again While you can braze a copper pipe end, you usually don't. You solder it. Use whatever type of fitting on the end that you need. If you are just stopping the pipe, use a cap. Clean both the pipe the the inside of the cap with steel wool or fine sandpaper. Apply a coating of flux to each surface where they overlap and put the cap on the pipe. Heat one side of the cap with a propane torch and hold the solder on the opposite side. When the cap get hot enough to melt the solder, it will draw the liquid solder around the pipe to the flame. Once it does that, remove the flame and allow it to cool before messing with it. That's all there is to it. You could braze the cap to the pipe, but that would only connect the edge of the cap where it meets the pipe. The brazing rod would not melt between the whole cap as solder does. If absolutely had to, you could crimp the end together and braze the joint. That's the last resort.
