is there a needle attached to the string if not there r other ways make a hole and put the string inside and go in and out and start moaning and giggiling
To put a string through a double pulley, first thread the string through one side of the pulley. Then, loop the string around the groove of the pulley and thread it through the other side. Make sure the string is running smoothly through both sides of the pulley before using it.
You get some Scooby beads and put them in through the string then tie the string
On the lid of your Nintendo ds pen, there is a bit of string. On your ds (where you put you game card in), there will be 2 small squares. Put the string through one of them and it should come out of the other. Then open the string and put the lid through the gap then pull on the lid.
To put a guitar string on properly, first unwind the old string and remove it. Insert the ball end of the new string into the bridge of the guitar. Thread the other end of the string through the tuning peg and tighten it. Tune the string to the correct pitch and trim any excess string.
put your finger through the loop and then pull.
Endothermic because you have to put heat into the potato to bake it.
if it is like a cage tie meet in bottom and put string through circular holes at top. when put all string you should be able to open and close it.
as long as a piece of string
make a trip wire. then get a pulley. then get the string to go through the pully then put the string on the trigger then tie the ends of the string together.
To put a guitar string on an acoustic guitar, first remove the old string by unwinding it from the tuning peg. Then, insert the ball end of the new string into the bridge and thread it through the corresponding tuning peg. Wind the string around the peg, tune it to the desired pitch, and trim any excess string.
To put a new string on a guitar, first remove the old string by loosening the tuning peg and unwinding it. Then, insert the ball end of the new string into the bridge or tailpiece, and thread the other end through the tuning peg. Wind the string around the peg, tune it to the desired pitch, and trim any excess string.
i 'll put potato's