answersLogoWhite

0

Yes, you can add an external coil to the magneto of an Allis-Chalmers engine to enhance the ignition system. This modification can improve spark strength and overall engine performance, especially in older models. However, it's essential to ensure compatibility with the existing ignition system and to follow proper installation procedures to avoid any electrical issues. Always consult the specific service manual for guidance on modifications.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

How do you check a coil on four wheeler?

if you have an ohm meter you can put it to the imput and out put on coil and kick it. it depends on size but it should be from 8 to 14 ohm


Could you Put coil in sentences?

Coils are cool.


Why does a motorcycle with a 6v system put out more volts at higher rpms?

Magneto/alternator is spinning faster creating a higher current flow


How do you make mosquito coil from carabao manure?

A mosquito coil is a type of repellent that is made in the shape of a coil. Carabao manure can be made into a paste or powder to put in or on the coil. This helps to repel mosquitoes.


What cOIL should you put for a 350 chevy engine with a HEI mallory distributor?

Stick with the coil recommended by Mallory.


What is involved in changing a coil pack on a 1999 Mercury Marquis without messing something else up?

Simple job. You should have coil on plug, just un plug, take off the coil, and put the new one on. If you have the coil pack , just remove and put the new one on.


Where did they put magneto while the plastic prison was being built?

maybe the prison was already built. or maybe they just kept him in a medically induced coma.


Can you put a coil pack from a 99 intrigue 3.5 into a 3.8?

no


How do you put spark plug wires in the right place on the coil pack on a 1995 Chevy Cavalier?

how do you put spark wires in the right place on the coil pack on a 1995 Chevy cavalier2.2 frank


How do you see if the coil is working on 2002 Chevy?

If theres a miss fire on a cylinder you check engine light will tell you.. Switch the coil from that cylinder to another and siwtch that coil to the cylinder that the computer says is missifing. If the cylinder you put your suspected coil on miss fires then you know its a bum coil.


How do you check the coil on a 2002 suzuki katana 600?

hook up a voltage meter to the coil put the meter on VDC measure the power going into the coil and going out. call a shop for the specs on the coil if its bad the whole assembly will need to be replaced.


How do you get a hose unfroze?

coil the hose and put it in a bucket of warm water..or if no warm water put in some water..