Put the cursor over your Speed World 2 that's in your field spell zone then press Activate. Then you can deal 800 damage to your opponent by showing a speed spell in your hand and removing 4 speed counters. If you do the same but remove 7 then you can draw one card, and if you want, remove 10 and destroy a card on the field. Some Speed Spells need you to remove speed counters to activate.
You do not remove the counter for the summon, you tribute Ancient Gear Castle itself. So imagine you have Ancient Gear Castle with one counter. You can tribute it for a Lv5/6 Ancient Gear monster - but since Ancient Gear Castle is now gone, it cannot gain another counter.
No you choose a new target and plz read the rule book.
The Magical Citadel's controller can remove the spell counter to save the Citadel from destruction during Heavy Storm's resolution.
Any card that actually uses Spell Counters will tell you what to do with them. Breaker the Magical Warrior tells you what his own counter does, while cards like Megaton Magical Cannon say to remove spell counters from other cards.
yeah 'reverse trap' or as a rule of thumb you could remove them from the field ' composory evacuation device, imterdimentional matter trasporter.' or filp them face down hope this is what you where looking for
Open the rear hatch, then remove the 4 screws holding the lens assembly to the vehicle. Remove the lens assembly by twisting it counter clockwise then pulling it out. Remove the bulb sockets by pressing in and turning counter clockwise then pulling it out. Do the reverse to put it back together.
Remove front wheel, remove caliper from hub, remove small counter sunk screws from rotor then knock off. rebuild in reverse. Hope this helps
Jack up the vehicle and remove the lug nuts. To remove the lug nuts you will have to turn them to the left or counter clockwise. Then you remove the wheel by pulling it toward you. If you reverse the procedure you can reinstall it.
Remove light protective cover by twisting counter clockwise Remove light bulb by twisting connector counter clockwise Pinch metal clips and remove wiring harness do not touch new bulb with fingers reinsert in housing connect wiring harness reverse above steps to complete process
1.remove the 2 screws holding the brake light housing on 2.remove the housing 3.1/4 turn counter clockwise will remove the desired bulb socket 4.press the bulb into the socket and 1/2 turn counter clockwise will remove the bulb from socket 5.repeat these steps in reverse order with new parts to install
counter clockwise to remove.counter clockwise to remove.
Remove the front inner wheel well splash shield. Grasp the bulb socket and rotate it counter-clockwise to remove it from the lamp. Remove the bulb from the socket. Installation is the reverse of removal.
The bulb socket twists out counter clockwise 1/4 a turn. Then remove the socket from the housing. Remove the bulb from the socket and replace with a new one. installations is reverse.
You have to remove the liner from the inside of the trunk lid, then remove the connector by turning it counter clockwise, then replace the bulb, check to make sure its working, then do the reverse to put it back. There might be a screw to remove the connector, but that's only a maybe...
Turn counter clockwise to remove.Turn counter clockwise to remove.
To remove or reverse a law
A website named bransport.com carries lug nut removers for various size lug nut locks. It uses a reverse thread that tightens on the lug nut as you turn it counter clockwise to remove.