0
If your Jeep Jimmys dies when you put it in gear, it could be due to several reasons. Common causes include a faulty torque converter, transmission issues, or problems with the engine's idle control system. Additionally, a vacuum leak or issues with the fuel system may also affect engine performance under load. It's best to have a mechanic diagnose the issue for proper troubleshooting and repair.
What else can I help you with?
Why does your van start but then die?
when does the car, like right after it is started or when you put it into gear
Why does your 1997 suburban die when put in gear?
Could have a large vacuum leak.
Motor dies when put into gear?
A motor will die when put in gear if there is a major vacuum leak. This causes an excessive amount of air to enter the engine and lean out the fuel mixture.
Why does jimmy get shot?
Jimmy gets shot by Rick. This happens because Spinner and Jay put the paint and feathers on Rick, but then blamed it on Jimmy. Rick gets angry and shoots Jimmy. Jimmy doesnt die, but is paralized , so needs to be in a weelchair.
Why is your 1995 gmc jimmy not shifting to the next gear from firt gear?
Your sun shell is broke
1988 Chevy Cheyenne dies when put in gear?
If a 1988 Chevy Cheyenne dies when it is put into gear, check the fuel pump. If the fuel pump is not getting adequate fuel, it will cause the car to die.
1979 Toyota corolla with 2T engine 3 speed Why does it die every time it is put into gear?
== ==
What would cause the transmission to make a whining noise when put into gear on a 1999 GMC Jimmy?
The torque converter might be going. but first check your fluid level.
What is the gear ratio of a 2001 GMC Jimmy 4x4?
The gear ratio of a 2001 GMC Jimmy 4x4 is probably 3.73. The ratio is listed on a plate in the glove compartment on most models.
Where do you put freon in at on a 2000 gmc jimmy?
where do you put freon in on a 2000 gmc jimmy
In Case Closed does Jimmy die?
As of May 2016, Jimmy does not die in the series.
If the car starts but when you put it in gear it cuts off?
car starts but when i put it in gear it stop
