=26 x (pressure in kpa times 75.0)/(8.31 x 293)
This is just a fancy way of saying acetylene which can be a liquid, a solid, or a gas depending on the temperature and pressure it is subjected to. Most often, under STP or RTP, acetylene is a gas.
Isobars are not measured. An isobar describes a part of a thermodynamic process during which the pressure doesn't change. It is also used as a term in graph tables where it describes the behavior of a material at a constant pressure.
A tube contains enclosed air by a thread of mercury of 250mm long when tube is horizontal the length of air is 250 mm long. The pressure on the air column when atmospheric pressure is 750 mm Hg is 3 Pascal or 3 N / m2.
375mmhg
air is composed OF matter
Acetylene is different from most gasses in a tank. An acetylene tank is not hollow- it contains a porous material (think of a hard sponge) that is saturated with liquid acetone. When acetylene is pumped into the tank under pressure, it dissolves in the liquid. This is similar to how carbon dioxide dissolves in a soda (in a bottle or an) under pressure. While in the tank, it is mainly in a liquid.
Acetylene is a gas at standard temperature and pressure.
15 psig. At pressures above that, acetylene can explode.
Acetylene gas is usually dissolved in acetone, as in this condition it occupies a much smaller volume. [But your acetylene cylinders should be kept vertical.] And acetylene under quite modest pressure is very explosive just by itself.
If there is pressure in the tank it may be possible to use it. If not I wouldn't recommend it. In the tank there are blocks of material and Acetone. These absorb the Acetylene allowing it to be charged to 300 PSI. If the Acetone (it is in liquid form) has leaked out the Acetylene could explode if the cylinder is recharged. Acetylene pressure is RED LINED at 35PSI.
OSHA standard, 1910.253(a)(2) says:Maximum pressure. Under no condition shall acetylene be generated, piped(except in approved cylinder manifolds) or utilized at a pressure in excess of 15psig (103 kPa gauge pressure) or 30 psia (206 kPa absolute). ... This requirementis not intended to apply to storage of acetylene dissolved in a suitable solvent incylinders manufactured and maintained according to U.S. Department ofTransportation requirements, or to acetylene for chemical use. The use of liquidacetylene shall be prohibited.
At normal temperature and pressure, it is approx 6.19 kilograms.
This is just a fancy way of saying acetylene which can be a liquid, a solid, or a gas depending on the temperature and pressure it is subjected to. Most often, under STP or RTP, acetylene is a gas.
240 Assuming ideal gas behavior, doubling the pressure means reducing the volume by a factor of 2.
Go and check safety regulations, and do it thoroughly. Some cylinders must be stored under very strict conditions - acetylene cylinders, for instance, contain a fusible pressure release plug that may leak acetylene, and an acetylene-air mixture is highly explosive. Check the regs.
Locally made aceytlene generators operates at low pressure (
If the volume remains constant, the pressure will increase as the temperature increases. In an ideal gas (under normal conditions, gases have a behavior that's close to that of an ideal gas), the pressure is directly proportional to the temperature. Assuming, of course, that the temperature is measured in Kelvin.