0
A balloon is weighted so that it is barely able to float in water. What will happen if it is pushed beneath the surface?
Wiki User
∙ 12y ago
It sinks. By pressing it under the water, the water pressure on the balloon increases slightly and compresses the air in the balloon. This increases the density of the (balloon, weight) combo so that is more dense than water, hence it sinks.
High altitude weather balloons are only inflated partway with helium when they are launched from the ground. The envelope of the balloon expands as it rises in the atmosphere.
Wiki User
∙ 12y ago
Wiki User
∙ 15y agoIt will float
Add your answer:
Earn +20 pts
What do you call the reflection of light from a rough surface?
Reflection of light from a rough surface is known as "Diffused" or "Irregular" reflection, because the light rays are barely seen after the reflection of light from a rough surface.
Sounds that are barely audible are describes as?
Sounds that are barely audible are describes as very quiet. To hear sounds that are very quiet your ears will usually have to strain.
Why does a knife have a sharp blade?
so you can cut things with no effort barely The sharp blade is due to the fact that there are relatively very few layers of atoms in it. When it is applied to a surface, the pressure it exerts is large since the surface area is small.
Why were tires invented?
Without tires, youll barely move and have no control of the car
What type of particle motion does a solid have?
barely any. they just vibrate in place.
How do you put a rope balloon on your transformice totem?
You can't. Here's the only way you can attach a balloon to your totem: 1. Take a balloon. Place it (like it was a box) where you want it on your totem. 2. Take a yellow anchor. Place the anchor wherever you want on the balloon! If the anchor does not show up on the screen, that means that you did not successfully attach the balloon to your totem. Make sure an object is actually behind your balloon before you anchor. The easiest way to attach balloons, is to put the balloons beneath your totem, so that the fat, round part (top) of the balloon is barely overlapping the part of your totem that you want to float / go upwards. Then yellow anchor it.
How do you put a rope on your transformice totem?
You can't. Here's the only way you can attach a balloon to your totem: 1. Take a balloon. Place it (like it was a box) where you want it on your totem. 2. Take a yellow anchor. Place the anchor wherever you want on the balloon! If the anchor does not show up on the screen, that means that you did not successfully attach the balloon to your totem. Make sure an object is actually behind your balloon before you anchor. The easiest way to attach balloons, is to put the balloons beneath your totem, so that the fat, round part (top) of the balloon is barely overlapping the part of your totem that you want to float / go upwards. Then yellow anchor it.
How did the human race conquer space?
It has not. We have barely 'scratched the surface.'
What mechanism that reads and writes items in the drive as it barely touches the disk and recording surface?
A read/write ____ is the mechanism that reads and writes items in the drive as it barely touches the disk's recording surface
How do you crack an egg perfectly?
barely tap the egg on the side of the counter or a hard surface
Why normal waves are different to tsunamis?
Normal ocean waves are a surface feature caused primarily by wind. Water beneath the surface is barely affected by what's going on at the surface. Tsunamis (often mistakenly called "tidal waves") are immense pressure waves caused by undersea earthquakes. Emerging from the epicenter of the quake, these waves propagate through the entire depth of the ocean and travel at close to 700 miles per hour. At sea, they are usually barely visible, but as soon as they approach shore, the shrinking depth of the water forces the pressure wave (and the water containing it) up to catastrophic heights.
What do you call the reflection of light from a rough surface?
Reflection of light from a rough surface is known as "Diffused" or "Irregular" reflection, because the light rays are barely seen after the reflection of light from a rough surface.
Does magma beneath the surface cool fast?
Magma cools down about a week or so it is extremely hot about 350 degrees Fahrenheit , when it cools down it turns into crystals which are inorganic, naturally, solid, and having a atom arrangement.
What keeps a water strider on the surface of water.?
One force I am positive about is surface tension- I can't explain too well because I am barely learning about this. I hope this answer helps you! =)
What forces keeps a water strider on the surface of water?
One force I am positive about is surface tension- I can't explain too well because I am barely learning about this. I hope this answer helps you! =)
Is a rust mite visible?
mites are barely visible to naked eye if on the right color surface, they are the size of a pencil dot
When do you dehorn a kid goat?
you should dehorn a kid goat when the tips of the horns are just barely above the surface of the skin
