LESS
Gas expands when heated and shrinks when cooled. If the gas inside a closed cylinder is cooled, it will shrink, so it will push against the walls less. Therefore, less pressure.
All metals expand when heated and contract when cooled. It is important, therefore, that the standard metre is kept at some constant temperature. That constant temperature could be any temperature but the triple point of water is a convenient benchmark.
The pressure inside the container would decrease.
The temperature to which air must be cooled to reach saturation is called the dew point.
Generally a solid. Although one also needs to take pressure in consideration to be exact.
At standard temperature and pressure, with a temperature of 25 C specified, bismuth is a solid. If the "room" is in a hot country and not artificially cooled, the bismuth might well be liquid instead.
hfhjuikui
Air temperature and air pressure are inversely proportional. As temperature increases, air pressure decreases. This is best demonstrated in an enclosed vessel.
Gas expands when heated and shrinks when cooled. If the gas inside a closed cylinder is cooled, it will shrink, so it will push against the walls less. Therefore, less pressure.
Gas expands when heated and shrinks when cooled. If the gas inside a closed cylinder is cooled, it will shrink, so it will push against the walls less. Therefore, less pressure.
Gas expands when heated and shrinks when cooled. If the gas inside a closed cylinder is cooled, it will shrink, so it will push against the walls less. Therefore, less pressure.
If pressure remains constant, then volume is directly proportional to temperature. Hot air is quite loud.
Evaporator Approach is the difference between the evaporating refrigerant temperature - measured at the well in the evaporator -and leaving chilled water temperature.Take all readings with the water cooled chiller at full load.Condenser Approach is the difference between the liquid refrigerant temperature - as measured on the liquid line - and leaving condenser water temperature.
Evaporator Approach is the difference between the evaporating refrigerant temperature - measured at the well in the evaporator -and leaving chilled water temperature.Take all readings with the water cooled chiller at full load.Condenser Approach is the difference between the liquid refrigerant temperature - as measured on the liquid line - and leaving condenser water temperature.
3.7 L
Ammonia is a gas. It is pressurized and cooled to liquify
It is a gas.Answer:Helium can be in any state (solid,liquid or gas) depending on its pressure and temperature. At 2.5 MPa:Below -272.20oC it is a solidAbove -268.93oC it is a gasBetween these two temperatures it is a liquid