What exactly is the question? Not everybody understands the lingo please explain.
chutya giri sala 1 to dalo MKC TMKC
One gallon of water weighs approximately 8.34 pounds, while one gallon of concrete weighs around 20-25 pounds, depending on the specific mix. Therefore, one gallon of concrete weighs more than one gallon of water due to the additional weight of the aggregates and cement in the concrete mix.
Slump tests can be subjective, leading to variations in results based on the operator's judgment. Additionally, they may not accurately reflect the workability of concrete in real-world conditions since they measure only the consistency of fresh concrete without accounting for factors like temperature and mix design. Furthermore, slump tests are limited to assessing only the plastic state of concrete, providing no insight into its hardened properties or long-term performance.
The average weight of concrete is 150 lb per cubic foot. However, lightweight concrete can weigh as little as 50 lb/ft3 and special mix designs (like those used in nuclear power plants) can weigh up to 400 lb/ft3.
The wet mix has moisture in addition to the components that have been used. The dry mix only has the individual components with no moisture or water.
Lean mix concrete is used for substructures like foundations,piles,etc.,Ready mix concrete is used for superstructures and also for mass construction.Generally, quality of ready mix concrete is good when compared to the lean mix concrete.Workability of lean mix concrete is high when compared to RMC.
Concrete mix is made from (sharp)sand, cement, aggregate and water. The ratios depent on the usage
1:2
Concrete :- a mix of cement, sand, water, and gravel. Mortar :- a mix of cement, sand, and water
Concrete mix is made from (sharp)sand, cement, aggregate and water. The ratios depent on the usage
Concrete :- a mix of cement, sand, water, and gravel. Mortar :- a mix of cement, sand, and water
The strength of concrete depends on the mix used to make it- ratio of cement, sand, gravel and water. If the mix does not produce a concrete that is strong enough, the concrete will break.
Its the process of selecting suitable ingredients of concrete and determining their relative amounts with the objective of producing a concrete of the required, strength, durability, and workability as economically as possible, is termed the concrete mix design.
The recommended mortar mix for concrete blocks is a 1:3 ratio of cement to sand.
The concrete mix should be a 5:1 Cement to water ratio. make sure you mix thoroughly when adding water. Look up "Concrete slump test"
The best method for securing a fence post using concrete mix is to dig a hole, place the post in the hole, pour concrete mix around the post, and then add water to the mix. Allow the concrete to set and cure before attaching the fence panels.
To efficiently mix concrete in a mixer for your construction project, follow these steps: Start by adding water to the mixer. Gradually add the concrete mix while the mixer is running. Mix the concrete for the recommended time, typically around 5 minutes. Check the consistency of the concrete - it should be smooth and free of lumps. Pour the mixed concrete into your project area promptly to prevent it from drying out.