More wire wrappings, Larger Iron core, more and stronger electricity, etc
Increasing the voltage, AC or DC, can make it stronger, if the wiring diameter allow such increasing of the current flowing across.
An electromagnet can be made stronger by: - A bigger iron rod. - A bigger battery/more batteries - More coils around the iron rod. - A bigger magnet. - Increase the current flowing through the coil. - Put in a soft iron core.
You run more copperwire around the coil, or induce more curent in the wire.
Mainly in that the electromagnet is NOT permanent. In other words, it can be switched on and off.Another relevant difference is that the electromagnet constantly requires power, at least while it is on.
My only guess is that ,,, because electromagnets are more stronger and powerful than the ordinary magnets. Moreover they provide continuous magnetic field required for the generator. the generator in your car will have an electromagnet in the field the field will set the charge rate new cars have an alternator the field is the electromagnet in the rotor older cars have a true generator where the field is in the stator
Yeah buddy - until something smokes. It does, and so does increasing the amp supply but you have to be careful not to melt the wire. Preferably you should increase both. -Good Luck Note; You automatically increase the amps being used by increasing the voltage applied.
To chew on it.
Adding more turns of wire to the electromagnet will make it stronger without changing the applied voltage.
An electromagnet's pulling force can be made stronger by introducing iron core in it.It increases the magnetic pull.
Yes, if you increase the number of coils or loops in an electromagnet, it's power increases.
You could either put a bar of iron in the center of the electromagnet, increase the voltage that you put in, or make more loops of wire.
The electromagnet is made stronger in proportion to the current given. Refer to the link provided for more information.AnswerWhen current passes through the coil of wire surrounding the core of an electromagnet, it acts to align the magnetic domains within that core. Once all the domains have been aligned, the electromagnet has reached 'saturation' and is as strong as it can get. So the strength of an electromagnet is NOT proportional to its magnetising current.
Neodymium
yes it can
Bolt
Bolt
You have to take it out on a nice date first. Second, you have to pleasure the magnet for exactly 42 minutes. Third, you rub tons of ranch dressing all over the magnet on each side and keep it on there for 3-4 hours. These are the steps to make your electromagnet stronger.
make an electromagnet stronger by doing these things: * wrapping the coil around an iron core * adding more turns to the coil * increasing the current flowing through the coil.