The time it takes to fill up a 50-gallon water heater depends on the water supply flow rate, typically measured in gallons per minute (GPM). If the flow rate is around 5 GPM, it would take approximately 10 minutes to fill the tank completely. However, this can vary based on Plumbing, water pressure, and the specific flow rate of the faucet or valve being used.
depends on water pressure, but it should completely fill in 15-20 minutes. the water should be hot in another 20-25 minutes if it has been run completely empty.
Usually about an hour.
"One hour for a new water heater" for a NEW one. If its a few years old, Id wait about 2 hours or so. That way it wont get cold while you are in the shower, and it can refill at the same time that it dispenses.
15 minutes to half an hour.
depends on the gal size and btu of the heater. look on the panel and it will tell you the gals and btu. also is it gas or electric, single element or double. most 40 to 50 gal heaters will recover in about 25 to 45 mins.I AM A MASTER PLUMBER LOCATED IN TEXAS. Hope this helps.
depends on water pressure, but it should completely fill in 15-20 minutes. the water should be hot in another 20-25 minutes if it has been run completely empty.
Usually about an hour.
The time it takes for a hot water heater to fill up completely can vary depending on the size of the tank and the water pressure. On average, it can take anywhere from 30 minutes to an hour for a hot water heater to fill up completely.
it only depends on pressure at which the water flows into the gallon
Around 3 hours
Around 3 days depending on water pressure.
Ususally about an hour or so...
I gallon of Long Life Coolant mixed with 1 gallon of distilled water will be enough to fill it up after draining.
Most are rated for 5-10 years depending on cost.
The answer depends on the flow rate or the water pressure, not just the pipe size.
About 4 seconds as it comes crashing to the ground
Upgrading to an 80-gallon electric water heater for residential use offers the benefit of providing more hot water capacity, allowing for longer showers and simultaneous use of multiple appliances. This can be particularly advantageous for larger households or homes with high hot water demand. Additionally, an 80-gallon electric water heater may be more energy-efficient and cost-effective in the long run compared to smaller capacity units.