The metal object would contract, i.e it would shrink.
it will slowly stop glowing
it will turn cool soon.
It depends on the metal. Opaque metals, aka black bodies, which are neither reflective nor translucent, will radiate predictably according to the color temperature scale. However, 1500K is not hot enough to cause a black body to radiate. My guess is that you will see no change in the metal if heated between 500K - 1500K, unless the metal is soft enough to melt at those temperatures. Either way, it's not likely to glow. A reflective metal, however, will probably reflect something based on the color of the flame that heats it.
That depends- what changes are you talking about? Please be specific.
Your compressor is not working. Through evaporation compressors cool the evaporator coil and the fan blows air across it. So if the fan is blowing hot air the compressor is not cooling the coil. But check to see if the dial inside the fridge is turned to "more cold" , that turns the compressor on.
Vehicles, chains, products mdae of metal bars
some types but if you took a periscope underwater you would see clear or black, oh and all the metal would rust.
'Ministry' - see related link below .
metal melts on heating because it gets hot
Start by checking to see if the cooling fans are coming on when it starts getting hot. If they are then you should start by checking: thermostat, temp switch & head gasket.
Cold rolling produces a better finish and is generally used for automotive body panel sheet metal. See link
The usual cause of cooling system pressure surges is a bad head gasket. The compression from the cylinders gets into the cooling system and raises the pressure. Have a mechanic run a compression test to see if there are any big pressure changes between the cylinders.
Check to see if you are getting power to fan - if so bad fan motorRun a hot line to fan to see if it starts - if not bad fan motorFan sensor bad?
Check to see if it is getting power - if so defective motor Run a "Hot" line to motor to see if it starts Check fuses Check sensor at rear of radiator
It depends on the metal. Opaque metals, aka black bodies, which are neither reflective nor translucent, will radiate predictably according to the color temperature scale. However, 1500K is not hot enough to cause a black body to radiate. My guess is that you will see no change in the metal if heated between 500K - 1500K, unless the metal is soft enough to melt at those temperatures. Either way, it's not likely to glow. A reflective metal, however, will probably reflect something based on the color of the flame that heats it.
If it is running hot then you need to service the cooling system. Drain and flush the radiator, replace the thermostat, check the operation of the water pump, see if the cooling fan is operating properly, and make sure the belts are tight and not slipping. Another possibility is a blown head gasket. Removing the thermostat is not the answer to an overheating problem.
This just happened to my Durango. You have 2 fans under the hood to cool the engine and a/c evaporator. One of the fuses under the hood fuse box is blown for 1 of the cooling fans. You will be able to see the metal in the fuse is broken/burnt.
Cooling towers are devices for dissipating waste heat to the atmosphere. Please see the link.
Alot of things. Check coolant levels. Check to see if you have any leaks. Check to see if radiator cooling fan(s) are working. Check oil level. Could be blown head gasket. Water pump could be going out. Cooling fan not working. Really need more info to help.