The blast saturation term is basically referring to the boiling point. Everything has a different boiling temperature so please be more specific about what you want to know.
The correct answer is zone of AERATION and NOT zone of SATURATION :)
To prevent saturation
Yes blasts are very useful even Final blast
Example sentence - The underground blast caused the mine to close.
about 29.4444
take your gages and put them on the beginning of the evaporator (afte metering device or txv) and look at saturation temp then get your temp at the suction line (before the compressor) then take you first temp and your second temp and subtract you highest temp from you lowest temp and that would be your superheat
take your gages and put them on the beginning of the evaporator (afte metering device or txv) and look at saturation temp then get your temp at the suction line (before the compressor)
With the A/C running Full-Blast @ Lowest Temp., You adjust R134 gauge according to Ambient Temp., & then add required amount of R134 until the black dial falls into the center of the Red 'Ambient Temp Zone'. Let engine run for 20 to 40 minutes with A/C remaining on Full Blast.
Water saturation temperature is the maximum temperature at which water can exist in a stable liquid state at a given pressure. It is the temperature at which water vapor in equilibrium with liquid water exerts a partial pressure equal to the vapor pressure of pure water at that temperature.
R-11, or trichlorofluoromethane, at a pressure of 18.1 inches of mercury (Hg) vacuum has a saturation temperature of approximately 32°F (0°C). This means that at this vacuum pressure, R-11 would begin to evaporate or boil at that temperature. It's important to consult a refrigerant pressure-temperature chart for precise values, as they may vary slightly depending on specific conditions.
The intensity or depth of a color is referred to as its saturation. Saturation describes how pure the color appears, with high saturation representing a vivid, intense color and low saturation indicating a more muted or washed-out appearance.
30 PSIG is about equal to 45 PSIA. Saturation temperature from the steam tables at 45 PSIA is about 274°F. So the steam would be 274°F, or hotter if superheated.
The saturation point can be determined using the density by measuring the density of the sample at different levels of saturation. The point at which the density no longer changes with increasing saturation is the saturation point. This is because at full saturation, the pores of the material are completely filled with the saturating fluid, leading to a maximum density.
what causes saturation in welding machine
who used saturation carpet bombing
To determine the saturation level in a substance, you can conduct a saturation test by adding the substance to a solvent until no more can dissolve. The point at which no more can dissolve is the saturation level.
Saturation - album - was created on 1992-12-17.