checklist
Number list
stage 1: PREPARATION list out some of the topics on an paper. be sure to include only those topics which brings entertainment quotient with them. Stage 2: CONDUCT random-ally , ask student to speak for one minute on the specific topic that u give to him or he chooses on by his own via chit system. the format for his speaking must be - a) Introduction b) body c) closing Stage 3: FEEDBACK give him feedback straightaway for his future betterment..
Basic format for any hypothesis has always been taught as; IF/Then. Ex. If there are 100mg of salt in the water then the water will freeze at a lower temperature Though there is not really any "format" to a hypothesis it is normally written in this format.
Get back into formation, soldier! Volcanic activity is central to the formation of new islands in the Hawaiian chain.
A hypothesis should be witten in a way that can be 1 tested by an experiment and 2 stated as a definite statement.
Number list
Every microprocessor architecture has a specific set of instructions that are embedded into the processor itself and each instruction correspond to a specific opcode. Data and instructions in memory are represented in an address format.
what is instruction length and what is instruction format and what is program length and what is the difference among them
the number of bits required to represent an instruction of a cpu is known as length of the instruction or known as instruction.
diagram
addressing mode is used to form an instruction format.
The connection between the hardware and software components of a computer creates the computer architecture. It is basically how the components are connected to form a complete system. Sir Frederick P. Brooks and Sir Lyle R. Johnson presented the idea of computer architecture in 1959. A set of operating codes, operands, an opcode, and an addressing mode make an instruction. The instruction format is the standard instruction format that is directly used by the CPU. The instruction format is just the sequence of bits (0,1). The group of these bits is called a field. Each field of the system provides specific information for a particular task to the CPU about the instruction's operation and the instruction's data. The most fundamental difficulty in format design is instruction length. The longer the command will, take longer the time to fetch it. The types of Fields are discussed below: Operation Field: It specifies the operations that are performed by the instructions like, ADD, SUB, etc. It can be any value or number on which the task has been performed. Operation field is mandatory for every instructor Address Field: It specifies the address of the operand. It refers to the address where the operand is stored. On the basis of multiple address fields, the instruction is categorised as follows: Zero address instruction: The operand positions are implicitly represented in zero address instructions. The stack-organized computer system supports these commands. One address instruction: This instruction manipulates data with the help of an implicit accumulator. Accumulator is a register that performs a logical process for the CPU. It uses one address field. Two address instructions: This address instruction is mostly used. This address command format has three operand fields. In the two address sections, registers or memory addresses can be used. Three address instructions: A three-address command must contain three operand components in its format. These three fields could be registers or memory locations. The instruction pipeline in computer architecture The instruction pipeline in computer architecture shows the system's instruction flow. It has 4 major segments, which are discussed below. Segment 1: The instruction fetch part can be performed using first in, first out (FIFO) buffers. Segment 2: The second section decodes the memory-fetched command before the effective location is computed in a different arithmetic circuit. Segment 3: The input is fetched from memory. Segment 4: The execution of the instructions is performed. Some of the features of instruction are : Addressing model: This is the first part of the instruction format. Data over the instruction format can be represented as an addressing format, and data is stored in the computer's memory or in the CPU's register OPCODE(operation code): This is the second part of the instruction format, and the opcode instructs the processor to perform the desired operation. Operand: Depending upon the processor instruction format, it contains zero to three operands, and this part specifies the data or points to the address of the data.
check list
One of its advantage is to save storage space.
format means to layout and specifically choose a format (text, centering or changing your data to a specific style)
numbered list
checklist