The purpose of heating the inoculating materials before and after using them is for sterilization. They must be sterilized before to kill any bacteria already on them so that they do not contaminate anything during use, and they must be sterilized after to get off the bacteria contacted from use.
The inoculating instrument must be cooled first before obtaining the inoculum. This prevents the bacteria from getting fried. Dead bacteria do not grow nor produce cultures.
otherwise the heat would kill the bacteria (inoculum)
If the inoculating instrument is too hot when obtaining the inoculum, it will "fry" the organism and kill it. It will, then, not grow when it is cultured.
Yes.
There is a leak somewhere in the cooling system. Have the cooling system pressure tested for leaks.
boi
Glass
Computers and their components typically generate a lot of heat during their operation. To keep the computer running properly and to keep it from overheating, all computers have some sort of system cooling in place. Fans are by far the most common tool in the use of system cooling. Fans can be found in just about every computer and computer component. They are in the CPU, the GPU or the PCI slot. They come in a variety of sizes from 40 to 120 mm, although fans as large as 200mm are beginning to enter the market. Fans are usually used in PCs, desktops and in computing data centers. Another type of system cooling is conductive and radiative cooling. This is most often used in laptops, cooling hard drives and optical drives through having them make contact with the computer’s frame, which increases the surface over which heat is radiated. A less common type of cooling is liquid submersion cooling. The computer components are submerged in a thermally conductive liquid. Cooling is achieved when heat is exchanged passively between the liquid, the computer’s parts and the ambient air. Liquid used in this type of cooling must have low electrical conductivity in order not to interfere with the computer’s operation. Liquids used for this purpose usually have been manufactured for it specifically, although various types of oils can also be used. If a full-featured computer is not needed, there is a way to achieve system cooling through waste heat reduction. In an office setting, very basic computers can be set up, such as diskless workstations or thin clients. This reduces the need for a hard drive at each workstation, so less cooling is required overall. In addition, the workstations can be powered from an external power supply so the computer itself does not heat up. The type of system cooling you choose will partly depend on your needs and resources. While air cooling through the use of fans is by far the most popular method, depending on your circumstances, you may want to investigate alternatives as well.
By using gaging instrument
An atomiser is an instrument for reducing a liquid to spray or vapour for disinfecting, cooling, medical use, or as a perfume spray.
Because too much heat can kill bacteria. Think of pasteurised milk - the pasteurising process involves rapid heating and cooling to kill off any bacteria that might be present in the milk.
Air cooling ,hydrogen gas cooling ,water cooling
There are dfferent types of cooling towers available in Industry. Some of the commonly is used cooling towers are Round Cooling Towers Square Cooling Towers Dry Cooling Tower Wooden Cooling Tower Cross Flow Cooling Tower Modular Cooling Towers Evaporative Cooling Towers Natural Cooling Towers Counter Flow Cooling Towers Get a highly durable cooling tower according to your industry.
water low in cooling system or faulty low water level sensor in filler expansion bottel.
nominal cooling capacity is the derated cooling capacity at a certain design condition. Rated cooling capacity is the cooling capacity at sea level
Motor cooling system? The engine cooling system consits of the water pump, radiator, hoses, cooling fans, etc.Motor cooling system? The engine cooling system consits of the water pump, radiator, hoses, cooling fans, etc.
Heatsink uses what they call passive cooling where as liquid cooling systems use active cooling.
Water cooling keeps your system cooler if you are constantly overclocking it. It does it far better than air cooling. However, the price for water cooling is higher than air cooling.
A notebook cooling stand is more versatile than a cooling pad, as it can be adjusted up or down for the user.
Range is the difference of cooling water inlet and cooling water outlet temp