0
Why does a block of plastic realeased under water come up to the surface of water?
Any time a mass is less dense than the liquid it is in, it will float. Said another way, when a volume of anything weighs less than the weight of the same volume of the liquid, it will float in that liquid. This applies to all fluids and gases, including why a hydrogen or helium balloon rises in the atmosphere, and how a submarine floats or sinks by altering the amount of weight on board (by intaking or expelling water, while its volume is a constant.) The plastic floats because it is less dense than the water (less weight compared to the same volume of water).
What else can I help you with?
What is a vapor barrier under a wood floor?
Vapor is another word for moisture. A vapor barrier is a sheet of plastic covering the entire surface under the floor to prevent moisture from causing the floor to warp or absorb stains. You would typically use a vapor barrier in basements with concrete floors.
When was Arising from the Surface created?
Arising from the Surface was created in 1980.
If enough water pressure builds under the surface of the ground the water can burst through cracks in the surface forming a n?
Geyser
Plutonic is also referred to as intrusive or extrusive?
Intrusive, or forming under the surface.
What is the surface temperature of eta piscium?
The surface temperature of Eta Piscium, the constellation Pisces' brightest star, is about 4930 Kelvin, or just a bit under 3000 degrees Fahrenheit.
A block of plastic is released under water will it sink or come up to the surface of water?
The density of water is greater than that of plastic. When a block of plastic is under water, the magnitude of the buoyant force or upthrust exerted by water on the block is greater than the magnitude of the weight of the block. Hence, the block of plastic released under water will come up to the surface of water.
Where are Citroen c5 spark plugs?
top of engine block under a moulded black plastic
Where is location of fuse block IN A 91 TRANS AM?
Under the dash, driver's side. Accessed by opening a plastic cover.
Where is the fuel filter on a 2006 Dodge diesel engine?
Left side of engine block, under black plastic screw on lid.
Where is the block heater plug located on a 2004 Chevy Aveo?
The block heater cord should be between your battery and fender. The cord is wraped in a plastic conduit and hang out under the hood when used.
Where is thermostat on Toyota Echo?
The thermostat is located under the alternator on the engine block. Just follow the lower radiator hose to the engine block and is held in place by plastic housing with two 10mm nuts.
How can I prevent a solid layer surface forming on hot chocolate?
A solid layer forming is due to oxidation of the surface. This cooling effect is due to the surface being exposed. To prevent this, you would need to get rid of all of the air and put a layer of plastic wrap over the surface without any air under the plastic.
Is quartz plastic?
No, its brittle under the stress and temperature conditions found at or near the Earth's surface. However if "stressed" it is piezoelectric.
Where does plast ic come from?
Plastic is made from oil which comes from oil pockets under the earth's surface, hope that helps :)
Where are the horn and horn relay on a 2000 Ford Escort ZX2?
Horn relay is located under the dash on a white plastic block. Did you get yours fixed?
Where are spark plugs on the 2005 trailblazer?
Under the air box above the block. Right under the piece of plastic that says vortec. You will see 6 heat sinks on head plug cap.
Where is the headlight fuse on a 2008 HD softail?
The fuse block is under your seat. There is a black plastic rectangular cover with the fuse block schematic printed on it. The headlight has its own fuse, 15amps, which are available in auto parts stores.
