It is best to remove the wall tiles. You need a flat service and a lot of times old tile will not be perfectly flat. If you remove the tiles you will have a good base to tile on. If you don't want to remove the tiles you may be able to add a backer board on top of the old tile and then tile on that.
I have tiled over cork tiles with ceramic tiles and it worked fine in a bathroom, around a bath. If the current tiles are really well fixed it should be fine.
It is possible but I would not reccomend it. If possible remove the old tile before laying the new tile. If you want to avoid removing the old tile you can lay a cement board over the old tile before installing the new tile.
I wouldn't recommend it. Most wall tiles are very smooth and wouldn't have any grit for the thin-set to adhere to.
To hang a bathroom sink over tile, first ensure the wall studs are properly located behind the tiles using a stud finder. Mark the sink's mounting bracket locations on the tiles, then drill holes through the tiles into the wall studs using a masonry bit. Insert wall anchors if necessary, then attach the mounting bracket securely. Finally, hang the sink on the bracket and ensure it's level before securing any plumbing connections.
That depends upon location. Tiles can be installed on a gypsum board wall or ceiling. (But make sure that the tiles are well grouted; if moisure gets past the tile into the gypsum board, it will be damaged.) Floors require greater strength - but then, you wouldn't normally have a gypsum board floor, with or without tile.
no the tiles have too smooth of a finish and other tile will not stick to them need to remove old tiles and then lay new
No, it is not recommended to use wall tile on the floor for a home renovation project as wall tiles are typically not designed to withstand the weight and foot traffic that floor tiles are subjected to. Using wall tiles on the floor may result in cracking or breaking over time. It is best to use floor tiles specifically designed for that purpose.
Having tiles untold bathrooms I always do the floor LAST this saves dropping tiles etc on to the nice new expensive tile. However, when tiling the walls first leave out the bottom row of wall tile (here you can place your straight edge datum, put in the floor tile then set that last row of wall tile and leave a 1/8" gap between the floor and wall tiles and fill with same water proof grout as the floor tiles have
To install tile on a wall, first prepare the surface by cleaning and priming it. Then, apply thinset mortar to the wall using a notched trowel. Press the tiles into the mortar, spacing them evenly with tile spacers. Allow the mortar to dry, then grout the tiles by spreading grout over them and wiping off excess with a damp sponge. Finally, seal the grout to finish the installation.
Ceramic tile contractors install ceramic tile floors in any room of a house, and they are specialized and do a great job. They also install other types of tiles, such as ceramic wall tiles, and ceramic countertop tiles.
You could but it's not advisableWall tile adhesive is thicker so it won't run down the wall and the tiles are less likely to slipANS 2 - I have done this a few times. If you use tile spacers, no problem.
YesANS 2 - I would only do that as a repair or an emergency. Floor tiles generally need a heavier and denser glue as they are being walked on - wall tile has no such stresses. ( -I have done lots of both types )
Some popular design trends for kitchen wall tile backsplashes include subway tiles, geometric patterns, bold colors, and textured tiles.
I have tiled over cork tiles with ceramic tiles and it worked fine in a bathroom, around a bath. If the current tiles are really well fixed it should be fine.
No, wall tile should not be used on the floor as it is not designed to withstand the weight and foot traffic that floor tiles are subjected to. Using wall tile on the floor can lead to breakage and safety hazards.
The most important aspect is to make sure everyone is Safe. Using an OTLVISE to move the Granite will reduce the working load and allow you to roll it. Clamps as well to lift it with. Many patents with this NEW and Innovative tool
You can use 8"tile.