0
What else can I help you with?
How much does grout weigh?
90 to 140 lbs/cf depending on the mix
How much did goliath sword weigh?
approximately 25 lbs
How much does a gallon of concrete weigh?
how much does a gallon of concrete weigh
How many pounds in a sq in?
None, lbs (pounds) is a measure of weight, sq in (square inches) is a measurement of area.
How much does one square of shingles weigh?
One bundle is about 90 lbs. 3 bundles to a square, so about 270 lbs. a square. Standard grade. Architectural are going to weigh more.
How much does grout weigh?
90 to 140 lbs/cf depending on the mix
How much water do you add to 10 lbs of grout?
Typically, for 10 lbs of grout, you would need to add approximately 1.4-1.6 gallons (5-6 liters) of water. It is important to check the specific instructions on the grout packaging as water requirements can vary.
How much grout do you need for 30 sqft of 12x12 tiles?
5 lbs at 1/4 inch joint.
How much area will a 50 pound bag of sand cover?
1 cubic foot=100 lbs of sand 1728 cubic in.=100 lbs of sand 864 cubic in.= 50 lbs of sand 432 cubic in.= 25 lbs of sand and so on and so on
What is the torque spec a 1996 Saturn valve cover?
DOHC cover is 89 in-lbs SOCH cover is 22 Ft-lbs
How much of an area does 60lbsand cover if it will be 2 inches thick?
In order to calculate the area coverage of 60 lbs and 2 inches thick, more information would be needed.Ê The information needed is what the 60 pounds is.ÊÊ To calculate area, you multiply width times height.
What is the torque setting for valve cover bolts for a 2000 jeep wrangler 4.0?
Valve cover is 85 in-lbs not ft-lbs
What is valve cover bolt torque for 1994 Chevy 350?
90in-LBS. NOT FT. LBS.
What is Chevy 1500 truck valve cover torque?
90 inch lbs. = 7.5 ft lbs
Weight of a man hole cover?
336 LBS.
How much area will 40 lbs of sand cover at 1 deep?
The area that 40 pounds of sand will cover at a depth of 1 inch can be estimated based on the density of sand, which is typically around 100 pounds per cubic foot. Since 40 pounds of sand is about 0.4 cubic feet, and 1 inch is ( \frac{1}{12} ) of a foot, the area covered would be approximately 4.8 square feet. Therefore, 40 pounds of sand will cover roughly 4.8 square feet at a depth of 1 inch.
Th 400 rear servo cover torque spec?
servo cover is 20 ft lbs... center support bolt is 25 ft lbs... solenoid bolts are 48 INCH lbs.. valve body is 120 INCH pounds. Front pump is 20 ft lbs.. gov cover works best with 15 ft lbs.. they say 20, but the gaskets always crush on this one..
