0
What else can I help you with?
How much space should be between the bottom of the door and the floor?
clearance between door and floor with forced air system
How much does Corelle clearance costs?
Corelle clearance varies based on its application as either Kitchenware, Dinnerware or Drinkware. Its cost can vary somewhere between $3 and $65 maximum.
If 8 counters are one whole then what is 12?
Twelve counters are one and a half (1.5)
How much clearance should there be when the pressure plate is assembled to the flywheel?
Need to know how much clearance where.
How much clearance between a rod bearing and a journal?
The clearance between a rod bearing and a journal typically ranges from 0.001 to 0.003 inches (0.025 to 0.076 mm), but it can vary depending on the engine design and application. Proper clearance is crucial for oil film formation, temperature management, and overall engine performance. Always refer to the manufacturer's specifications for the optimal clearance for specific engines.
What counters can you get to the other side in chess?
pretty much all them
How much clearance is needed between a dining table and the wall for dining chairs to be pulled out comfortably?
90 cm minimun
How much clearance is required between plumbing and electrical underground services?
I do not think there is an actual code but general rule of thumb is 1 foot between all utilities.
What is rivet clearance?
Rivet clearance refers to the gap or space between the rivet and the hole in which it is inserted. This clearance is essential for ensuring proper installation and allows for thermal expansion, manufacturing tolerances, and potential misalignment during assembly. Adequate rivet clearance helps to prevent stress concentrations and ensures the structural integrity of the joint. Too much clearance can compromise strength, while too little can hinder proper installation.
How much clearance between shaft diameter and labyrinth seal?
Labrynth seal clearances depend up the diameter of the rotating shaft, bearing clearance & temperature of the lubricating medium. As ageneral thumb rule the clearance must be 0.03 mm per 1" dia of shaft.
What is mean with the term oil clearance?
Oil clearance refers to the gap or space between moving parts in an engine or machinery where oil can flow. It is critical for ensuring proper lubrication, reducing friction, and preventing wear between components such as bearings and shafts. Maintaining the correct oil clearance is essential for optimal performance and longevity of the engine, as too little clearance can lead to oil starvation, while too much can increase oil consumption and reduce efficiency.
How much clearance is need around 18000 volts to keep it from jumping to ground?
18000 volts clearance
