no because it it is to dence for the water which it will make it appear wider but it will not spread out
The total force exerted on the bottom of a container completely full of water is equal to the weight of the water above it, which can be calculated using the formula F = ρghA, where ρ is the density of water, g is the acceleration due to gravity, h is the height of the water column, and A is the area of the bottom of the container.
They molt between 14 and 17 times before they settle to the bottom and begin to take on adult characteristics.
The weight of a shovel full of red clay can vary depending on the moisture content of the clay and the size of the shovel. On average, a shovel full of red clay can weigh around 20-30 pounds.
The bottom of your dishwasher may be full of water due to a clog in the drain hose, a malfunctioning pump, or a faulty float switch. It is important to troubleshoot and address the issue promptly to prevent further damage to the appliance.
Clay
There are several methods used to cook terracotta clay. One method is to fill the pot two thirds full of water and bake at 225 for up to 3 hours.
incorrect
Heat transfer in a pot full of water occurs through conduction, where the heat energy moves from the hot bottom of the pot to the cooler water molecules, causing them to increase in temperature. Convection also plays a role, as the heated water near the bottom rises, transferring heat throughout the pot.
There are several possible reasons why your dishwasher may be full of water at the bottom. It could be due to a clog in the drain hose, a malfunctioning pump, a faulty float switch, or a problem with the water inlet valve. It is recommended to check these components and consult a professional if needed to diagnose and fix the issue.
Rain water falling from the sky, as part of the water cycle, will sink into the ground and top up the water table. Or the water will flow off the ground surface and eventually form streams and rivers as the water heads towards the sea. But, some of the water will fill depressions in the land, and if the bottom of the depression is clay and not porous, the water would remain as a lake.
Bubble top has a replaceable top can of higher capacity and a permanent can at the bottom of lower capacity. When we invert the sealed replaceable can filled with water and place it on the permanent can, the piercing agent in the bottom half opens the seal and water from the top can flows out to fill the permanent can, from which we consume water. While doing so water enters into the top can as bubbles and fills the sapce above the water in the inverted can. The atmospheric pressure outide balances the water in the top can. As we consume the water in the bottom can, water level in the bottom can drops down and exposes the water in the top can. This drops down again to fill the bottom can till the pressure balances the weight of water. (Note ::: if there is leak in the joint between the bottom and top can (Or) If the bottom of the Top can has a minor crack..full water drops from it into bottom and hence spills out..) ... Have a great day....An Engineer