0
What else can I help you with?
Why 4 and6 marking absent in Williams probe?
to avoid confusion
Why 4 and 6 markings are absent on Williams periodontal probe?
The 4-mm and 6-mm markings are absent to improve visibility and avoid confusion in reading the markings
Why 4 and 6 markings absent in Williams probe?
1. to avoid parallax error 2. to easily distinguish between shallow and deep pockets
Why 4 and 6 marking are missing in Michigan o probe with Williams markings?
to avoid confusion
Why 4 and 6 markings are not present in Williams graduated probe?
The absence of 4 and 6 markings on the Williams graduated probe is primarily due to its design intended for specific dental measurements. The probe typically features markings at intervals that correspond to common periodontal assessment depths, which are more relevant in clinical practice. Additionally, the standardization of markings aids in consistency and accuracy during examinations, focusing on the most critical measurements for dental health assessment.
Can put a Ford Probe gt bumper on a Ford Probe base?
NO you can't because a ford probe Gt is a v6 while the ford probe base is a flat 4. Because of this the car is shaped differently including the bumper so you need to order a bumper for a base ford probe. this guy is wrong it is a direct bolt on and its inline 4 not flat 4
If there are 32 students in a class and 4 students were absent what percent of kids were absent?
like about 19 or 20 %
What is the firing order for a 1994 Ford Probe 2.0L?
your firing order for your probe is 1-4-3-2
What is the percentage if 4 out of 16 children are absent?
25%
Where do you locate the fuel pump on a 93 Ford Probe?
Were do I locate the fuel filter on a 1993 Ford probe 4 cylinder
1994 Ford Probe squeals when started?
I Have 94 Probe 4 cylinder that squealed when I started it. the pully on the water pump was lose
How do you set ignition timing on a 1989 ford probe?
where are timing marks on 89 ford probe 4 cylinder I have the bottom not the top
