0
It depends on the type of sparking/arcing. If you mean in a DC or series-wound motor, it is caused by the making and breaking of the commutator segments against the motor brushes.
If you mean under a car, then it could mean that the muffler is dragging the ground.
If you mean in a CRT television, then it is likely problems with the flyback transformer.
What else can I help you with?
What causes sparking at the brushes in amotor?
It has static charges. Or it may be combustible, that's why it spark and went to flame.
What causes the overheating of commutator in dc motor?
brush friction, poor ventillation, excessive sparking caused by high voltage
Does a huge sparking on the pole can make an electricity meter run fast?
A huge sparking on the pole can make an electricity meter run fast if it causes a surge in electrical current. The meter monitors the amount of electricity flowing into the home which is regulated by items in the home itself.
Why sparking in electrical switches?
If you get sparking in an electrical switch there is a loose connection or short in the circuit. The switch should be repaired or replaced.
What is the sparking agent in a lighter?
The flint.
What does sparking mean?
It means to connect with someone you like and love them.
What actors and actresses appeared in Sparking the Flame - 2010?
The cast of Sparking the Flame - 2010 includes: Matt Christian Reed as Henry
Are power lines sparking a common cause of electrical fires?
Yes, power lines sparking can be a common cause of electrical fires.
What causes sparking in an electric buzzer?
The buzzer work with a magnetic coil that attractes the armature thus interrupting the current. This happens repeatedly to cause the buzz. When the current is interrupted the action of the coil produces a voltage that tries to maintain the current, and that causes a spark between the switch contacts.
Ht leads not sparking?
Good. They are not supposed to.
What is EExn Atex rated?
non sparking
How do you set off the barrel of explosives on nabooti island?
The explosives in the diamond mine are just to the left of the elevator. Turn off the elevator switch that's sparking, then push the explosives to the right. You turn the sparking switch back on to detonate it.To use the explosives:Turn off the sparking wire from the elevator switch.Slide a barrel of explosives over to the right, and put it next to the rock.Turn the switch back on, sparking the explosive, which explodes the rock.Turn the sparking wire off, and repeat the process to blast the wall.
